The diameter of longitudinal bars of a column should never be less than?

6 mm
8 mm
10 mm
12 mm

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

4 views Answered 2022-09-01 13:21

Related Questions

In working stress design, permissible bond stress in the case of deformed bars is more than that in plain bars by?

1 Answers 7 Views

The minimum cover in a slab should neither be less than the diameter of bar nor less than?

1 Answers 4 Views

For a longitudinal reinforcing bar in a column, the minimum cover shall neither be less than the diameter of bar nor less than?

1 Answers 4 Views

The minimum diameter of longitudinal bars in a column is?

1 Answers 4 Views

The diameter of main bars in R.C.C. columns, shall not be less than?

1 Answers 5 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

An R.C.C. column is treated as short column if its slenderness ratio is less than?

1 Answers 4 Views

The diameter of transverse reinforcement of columns should be equal to one-fourth of the diameter of the main steel rods but not less than?

1 Answers 8 Views

According to load factor method, the permissible load ‘W’ on a short column reinforced with longitudinal bars and lateral stirrups, is?

1 Answers 5 Views

If Ac, Asc and A are areas of concrete, longitudinal steel and section of a R.C.C. column and m and σc are the modular ratio and maximum stress in the configuration of concrete, the strength of column is?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)