The floor slab of a building is supported on reinforced cement floor beams. The ratio of the end and intermediate spans is kept?

0.7
0.8
0.9
0.6

LohaHridoy

7 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

7 views Answered 2022-09-01 13:21

Related Questions

In counterfort type retaining wallsi) the vertical slab is designed as a continuous slabii) the heel slab is designed as a continuous slabiii) the vertical slab is designed as a cantileveriv) the heel slab is designed as a cantileverThe correct answer is?

1 Answers 6 Views

The simply supported beam 'A' of length '$$l$$' carries a central point load 'W'. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is 'W'. The ratio of maximum deflections between beams 'A' and 'B' is?

1 Answers 5 Views

A simply supported beam A carries a point load at its mid span. Another identical beam B carries the same load but uniformly distributed over the entire span. The ratio of the maximum deflections of the beams A and B, will be?

1 Answers 4 Views

If the ratio of long and short spans of a two way slab with corners held down is r, the actual reduction of B.M. is given by?

1 Answers 7 Views

Long and short spans of a two way slab are ly and lx and load on the slab acting on strips parallel to lx and ly be wx and wy respectively. According to Rankine Grashoff theory?

1 Answers 5 Views

For a continuous floor slab supported on beams, the ratio of end span length and intermediate span length, is?

1 Answers 4 Views

If l₁ and l₂ are the lengths of long and short spans of a two way slab simply supported on four edges and carrying a load w per unit area, the ratio of the loads split into w₁ and w₂ acting on strips parallel to l₂ and l₁ is?

1 Answers 9 Views

If K is a constant depending upon the ratio of the width of the slab to its effective span l, x is the distance of the concentrated load from the nearer support, bw is the width of the area of contact of the concentrated load measured parallel to the supported edge, the effective width of the slab be is?

1 Answers 5 Views

Assertion A : For identical strength, a composite cement-lime mortar is preferred over cement mortar.Reason R : Composite cement-lime mortar has higher drying shrinkage than cement mortar.Select your answer based on the codes given below. Codes:?

1 Answers 5 Views

For testing compressive and tensile strength of cement, the cement mortar is made by mixing cement and standard sand in the proportions of?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)