A shaft subjected to a bending moment M and a torque T, experiences?

Maximum bending stress = 32M/πd³
Maximum shear stress = 16 T/πd³
Both A and B
Neither A nor B

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

5 views Answered 2022-09-01 13:21

Related Questions

Sinking of an intermediate support of a continuous beami) reduces the negative moment at supportii) increases the negative moment at supportiii) reduces the positive moment at center of spaniv) increases the positive moment at center of span The correct answer is?

1 Answers 4 Views

Two shafts A and B are made of the same material. The diameter of shaft A is twice as that of shaft B. The power transmitted by the shaft A will be __________ of shaft B.?

1 Answers 4 Views

The bending moment ‘M’ and a torque ‘T’ is applied on a solid circular shaft. If the maximum bending stress equals to maximum shear stress developed, then ‘M’ is equal to?

1 Answers 5 Views

A hollow shaft will transmit a __________ torque than a solid shaft of the same mass and same material.?

1 Answers 5 Views

If Th is the torque resisting capacity of a hollow shaft and Ts is that of a solid shaft, of the same material, length and weight. Then,?

1 Answers 8 Views

If Kh is the torque resisting capacity of a hollow shaft and Ks is that of a solid shaft, of the same material, length and weight. Then,?

1 Answers 7 Views

The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called?

1 Answers 5 Views

A shaft of diameter D is subjected to a twisting moment (T) and a bending moment (M). If the maximum bending stress is equal to maximum shear stress developed, then M is equal to?

1 Answers 4 Views

A shaft is subjected to bending moment M and a torque T simultaneously. The ratio of the maximum bending stress to maximum shear stress developed in the shaft, is?

1 Answers 5 Views

If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)