The ________ is a standard element of a section view in a technical drawing.?

Cutting Plane line
Section lines
Material hatch pattern
All of the above

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

6 views Answered 2022-09-01 13:21

Related Questions

Drafters should use a ________ in a section view of a mechanical part that includes the cylindrical view of a threaded hole.?

1 Answers 4 Views

The offset distance for the width (front to back) distance of the auxiliary view is the same distance of the ________ in the top view.?

1 Answers 4 Views

A full scale technical drawing will have a scale factor of ________.?

1 Answers 4 Views

The first step in creating a traditional technical drawing is to ________.?

1 Answers 6 Views

The lines used to create the auxiliary view should appear as ________ in the finished view.?

1 Answers 5 Views

In order to set drawing limits for a 'C' size architectural drawing the drafter should set the limits to ________.?

1 Answers 8 Views

In developing a multi-view drawing, the drafter can use a ________ line to help locate the top and right side views.?

1 Answers 6 Views

In multi-view drawing it is common practice to include three views, the front, the top and the right side. If no dimensions are required on the right side view the drafter can ________.?

1 Answers 4 Views

section modulus of a square section of side B and that of a circular section of the ratio of the diameter D, is?

1 Answers 5 Views

To determine the discharge at a section in a stream from its rating curve, the required data are i) slope of water surface at the section ii) stage at the section iii) current meter readings at the section The correct answer is?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)