The power source that drives the manipulator can be:?

pneumatic
electric
hydraulic
All of the above
None of the above

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

4 views Answered 2022-09-01 13:21

Related Questions

This mention statement is associated with “Any number of current sources in parallel may be replaced by a single current source whose current is the algebraic sum of individual currents and source resistance is the parallel combination of individual source resistances”.?

1 Answers 9 Views

A pick-and-place manipulator is:?

1 Answers 4 Views

Robotic manipulator arms mostly use?

1 Answers 4 Views

You cannot convert a voltage source to an equivalent current source, or vice versa.?

1 Answers 4 Views

In order to get maximum power transfer from a capacitive source, the load must have an impedance that is the complex conjugate of the source impedance.?

1 Answers 4 Views

A synchronous motor installed at the receiving end substation operates with such an excitation that it takes power at lagging power factor. Now if the applied voltage of the synchronous motor goes down, the power factor of the synchronous motor will?

1 Answers 9 Views

The power rating of a resistor determines the minimum power that it can handle safely.?

1 Answers 4 Views

The output power of a transistor amplifier is more than the input power because the additional power is supplied by ___________?

1 Answers 5 Views

The ratio of driving tensions in V-belt drives is __________ flat belt drives.?

1 Answers 5 Views

The ratio of the indicated power to the shaft power or brake power of the motor or engine required to drive the compressor, is called?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)