The heat treatment process to which castings and the steel balls produced by cold heading are subjected is?

Tempering
Normalising
Annealing
None of these

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

Whitworth compressed steel is obtained when molten steel is subjected to a pressure of?

1 Answers 5 Views

Steel will respond to hardening by heat treatment processes, only when the minimum carbon content in it is __________ percent.?

1 Answers 5 Views

Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)?

1 Answers 7 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

The sensible heat factor during the heating and humidification process is given by (where h₁ = Enthalpy of air entering the heating coil, h₂ = Enthalpy of air leaving the heating coil, and hA = Enthalpy of air at the end of humidification process)?

1 Answers 5 Views

Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)?

1 Answers 9 Views

Which of the following are reasons for the chief fishing grounds being located in continental shelf areas where cold and warm currents meet I. Warm currents are rich in phosphates and nitrates II. Plankton - the chief fish feed - thrives in these regions III. The meeting of cold and warm currents allows the water to be well aerated IV. The epicontinental seas allow sunlight to reach almost to the bottom?

1 Answers 4 Views

Which of the following steel making process is being adopted at Rourkela (in India) Steel Plant?

1 Answers 6 Views

Which of the following heat treatment processes is usually applied to castings ?

1 Answers 5 Views

In a heating process, a heat flow diagram in which the quantities of heat in the various items of a heat balance are represented by the width of a band is called the?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)