Choose the most important factor on which the heat conducted through a wall in a unit time will depend on?

Thickness of the wall
Area of the wall perpendicular to heat flow
Material of the wall
Temperature difference between the two surfaces of the wall

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

4 views Answered 2022-09-01 13:21

Related Questions

A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when?

1 Answers 9 Views

Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)?

1 Answers 7 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

A vertical wall is subjected to a pressure due to one kind of liquid, on one of its sides. The total pressure on the wall per unit length is (where w = Specific weight of liquid, and H = Height of liquid)?

1 Answers 6 Views

If ‘H’ is the height of wall between centers of supports, then the effective height of wall where concrete floors have a bearing on wall irrespective of the direction of span will be?

1 Answers 6 Views

Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)?

1 Answers 9 Views

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.?

1 Answers 5 Views

Ethernet and Token-Ring are the two most commonly used network architectures in the world. Jim has heard of the different topologies for networks and wants to choose the architecture that will provide him with the most options. Which of the following would that be Choose the most correct answer.?

1 Answers 9 Views

Which of the following is/are true of world time zones I. The world is divided into thirty time zones II. All time zones of the world are described in term of the number of hours difference between the standard meridian of that zone and the Greenwich Meridian III. All countries have more than one time zone IV. The time for all places east of Greenwich is designated slow, and time for all places left of Greenwich is designated fast?

1 Answers 5 Views

Heat gain through insolation and heat loss through terrestrial radiation are equal approximately at which latitude?

1 Answers 12 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)