Which of the following is not increased by using preheated combustion air in place of ordinary air at room temperature?

Calorific value of the fuel
Flame temperature achieved
Speed of combustion of fuel
Heat transfer rate to the stock in the furnace

LohaHridoy

8 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

8 views Answered 2022-09-01 13:21

Related Questions

When the air is passed through an insulated chamber having sprays of water maintained at a temperature higher than the dew point temperature of entering air but lower than its dry bulb temperature, then the air is said to be?

1 Answers 7 Views

When water is sprayed on air, passing through an insulated chamber maintained at a temperature higher than the dew point of entering air but lower than its dry bulb temperature, then the air is?

1 Answers 5 Views

Equal volumes of aniline and diesel oil when mixed at room temperature (during summer) was found to be completely mis-cible. It means that the aniline point of the diesel is __________ the room temperature.?

1 Answers 6 Views

The bypass factor (B. P. F.) in case of sensible heating of air is (Where td₁ = Dry bulb temperature of air entering the heating coil, td₂ = Dry bulb temperature of air leaving the heating coil, and td₃ = Dry bulb temperature of heating coil)?

1 Answers 5 Views

The bypass factor, in case of sensible cooling of air, is given by (where td₁ = Dry bulb temperature of air entering the cooling coil, td₂ = Dry bulb temperature of air leaving the cooling coil, and td₃ = Dry bulb temperature of the cooling coil)?

1 Answers 5 Views

The ratio of thermal & electrical conductivity is same for all the metals at the same temperature ; and at around room temperature, this ratio is proportional to(where, T = absolute temperature, °K)?

1 Answers 7 Views

Which of the following advantages is not associated with the use of preheated air for combustion of a fuel in the furnace?

1 Answers 5 Views

In a furnace operation, which is not preheated?

1 Answers 5 Views

If the solubilities of different components (in a liquid-liquid extraction system) increase with rise in temperature, then the temperature above which they dissolve completely is known as the critical solution temperature (CST or consolute temperature). If solubilities increase with decrease in temperature, then CST is the temperature below which they dissolve completely. If a binary system has no critical solution temperature, it implies that?

1 Answers 6 Views

Which of the following are true with regard to temperature control of the atmosphere of a given place I. The major temperature contrasts on earth's surface are between land masses and oceans II. During night, the water surface cools more rapidly than the land surface III. Temperature generally decreases with latitude on either side of the equator IV. Temperature rises to a maximum during summer and falls to a minimum during winter?

1 Answers 8 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)