Young’s modulus of a wire is defined as the stress which will increase the length of wire compared to its original length by?

Half
Same amount
Double
One-fourth

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

4 views Answered 2022-09-01 13:21

Related Questions

When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)?

1 Answers 5 Views

When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy), the maximum normal stress is?

1 Answers 5 Views

When a body is subjected to a direct tensile stress (σx) in one plane accompanied by a simple shear stress (τxy), the minimum normal stress is?

1 Answers 13 Views

The strain energy stored in a body due to shear stress, is (where $$\tau $$ = Shear stress, C = Shear modulus and V = Volume of the body)?

1 Answers 5 Views

The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)?

1 Answers 5 Views

Which of the following relationships is correct for relating the three elastic constants of an isotropic elastic material (where, E = Young's modulus, G = Modulus of rigidity or shear modulus v = Poisson's ratio)?

1 Answers 4 Views

The ratio of the length and depth of a simply supported rectangular beam which experiences maximum bending stress equal to tensile stress, due to same load at its mid span, is?

1 Answers 8 Views

The ratio of the length and diameter of a simply supported uniform circular beam which experiences maximum bending stress equal to tensile stress due to same load at its mid span, is?

1 Answers 13 Views

Three elastic constants for a completely anisotropic elastic material which follows the Hooke's law are young's modulus, elastic limit stress and yield stress. Which of the following properties is most sensitive to increase in strain rate ?

1 Answers 5 Views

The design stress, which is more than the damaging stress, is the least unit stress that will render a member unfit for service before the end of its normal life. The design stress factor or factor of safety indicates the margin between design stress and the __________ stress.?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)