The ratio of the length and diameter of a simply supported uniform circular beam which experiences maximum bending stress equal to tensile stress due to same load at its mid span, is?

1/8
1/4
1/2
1/3

LohaHridoy

13 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

13 views Answered 2022-09-01 13:21

Related Questions

When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor and W = Axial compressive load on the spring)?

1 Answers 5 Views

For a simply supported beam of length 'L', when a concentrated load W is applied in the center of the beam, the maximum deflection is?

1 Answers 5 Views

a uniform circular bar of diameter d and length , which extends by an The deflection of amount under a tensile pull , when it carries the same load at its mid-span, is?

1 Answers 8 Views

When a uniformly distributed load, longer than the span of the girder, moves from left to right, then the maximum bending moment at mid section of span occurs when the uniformly distributed load occupies?

1 Answers 6 Views

A simply supported beam with a gradually varying load from zero at ‘B’ and ‘w’ per unit length at ‘A’ is shown in the below figure. The shear force at ‘B’ is equal to?

1 Answers 5 Views

A simply supported beam of length 'l' carries a point load 'W' at a point C as shown in the below figure. The maximum deflection lies at?

1 Answers 9 Views

The natural frequency of free transverse vibrations due to uniformly distributed load acting over a simply supported shaft is (where $$\delta {\text{S}}$$ = Static deflection of simply supported shaft due to uniformly distributed load)?

1 Answers 8 Views

The natural frequency of free transverse vibrations due to a point load acting over a simply supported shaft is equal to (where $$\delta $$ = Static deflection of a simply supported shaft due to the point load)?

1 Answers 6 Views

The ratio of the length and depth of a simply supported rectangular beam which experiences maximum bending stress equal to tensile stress, due to same load at its mid span, is?

1 Answers 8 Views

A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)