Minimum pitch of the rivets shall not be less than (where d is gross diameter of rivet)?

1.5 d
2.0 d
2.5 d
3.0 d

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

5 views Answered 2022-09-01 13:21

Related Questions

When the axis of load lies in the plane of rivet group, then the most heavily loaded rivet will be the one which (where, Fa is the load shared by each rivet due to axial load and Fm is the shearing load due to moment in any rivet.)?

1 Answers 10 Views

Which of the following property sets pitch or tone (high or low) for the synthesized speech when reading an element; the pitch may be specified absolutely or relative to the normal pitch for the voice-family used to read the text?

1 Answers 4 Views

In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)?

1 Answers 5 Views

According to I.B.R., shearing resistance required to shear off the rivet per pitch length (in double shear) is (where n = Number of rivets per pitch length)?

1 Answers 7 Views

Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole and $${\sigma _{\text{t}}}$$ = Permissible tensile stress for plate material)?

1 Answers 6 Views

In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)?

1 Answers 4 Views

The pull required to tear off the plate per pitch length is (where p = Pitch of rivets, t = Thickness of plates and $${\sigma _{\text{t}}},\,\tau $$ and $${\sigma _{\text{c}}}$$ = Permissible tensile, shearing and crushing stresses respectively)?

1 Answers 10 Views

Minimum pitch provided in riveted steel tanks is (where d is diameter of rivets)?

1 Answers 13 Views

In a shell and tube heat exchanger having square pitch, the shell side equivalent diameter is given by (where, P = pitch, d = outside diameter of the tube)?

1 Answers 7 Views

A triple riveted butt joint with double straps of unequal width is to be designed for a boiler shell. The pitch of the rivets in the outer row is double the pitch in the inner row and zigzag riveting is proposed. Which of the following statement is correct?

1 Answers 39 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)