The indicated power of a four stroke engine (in watts) is equal to (where P = Mean effective pressure in N/m², L = Length of stroke in metres, A = Cross-sectional area of the piston in m², and N = Speed of the engine in revolutions per second (r.p.s)?

P.L.A.N/2
P.L.A.N
2 × P.L.A.N
P.L.A.N/4

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

4 views Answered 2022-09-01 13:21

Related Questions

In the below figure, PC is the connecting rod and OC is the crank making an angle $$\theta $$ with the line of stroke PO and rotates with uniform angular velocity at $$\omega $$ rad/s. The Klien's acceleration diagram for determining the acceleration of the piston P is shown by quadrilateral CQNO, the acceleration of the piston is _________ when the crank OC and connecting rod PC are at right angles to each other.?

1 Answers 5 Views

In the below figure, PC is the connecting rod and OC is the crank making an angle θ with the line of stroke PO and rotates with uniform angular velocity at $$\omega $$ rad/s. The Klien's acceleration diagram for determining the acceleration of the piston P is shown by quadrilateral CQNO. The acceleration of the piston P with respect to the crank-pin C is given by?

1 Answers 4 Views

The change in length due to a tensile or compressive force acting on a body is given by (where P = Tensile or compressive force acting on the body, $$l$$ = Original length of the body, A = Cross-sectional area of the body and E = Young's modulus for the material of the body)?

1 Answers 5 Views

The discharge of a double acting reciprocating pump is (where L = Length of stroke, A = Cross-sectional area of piston, and N = Speed of crank in r.p.m.)?

1 Answers 5 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

Which of the following is correct (Where pa = Actual mean effective pressure, pm = Theoretical mean effective pressure, and K = Diagram factor)?

1 Answers 6 Views

The mechanical efficiency (ηm) of an I.C. engine is equal to (where I.P. = Indicated power, B.P. = Brake power and F.P. = Frictional power)?

1 Answers 5 Views

Resistance of an electrical conductor is proportional to its (where, l = length and A = cross-sectional area of the conductor)?

1 Answers 4 Views

The pressure drop per unit length for laminar flow of fluid through a long pipe is proportional to (where, A = cross-sectional area of the pipe & D = Diameter of the pipe)?

1 Answers 4 Views

A compound steam engine in which the high pressure and low pressure cylinders have common piston rod, is called?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)