Which of the following is correct (Where pa = Actual mean effective pressure, pm = Theoretical mean effective pressure, and K = Diagram factor)?

pa = pm/K
pa = pm × K
pa = K/pm
pa = pm + K

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

6 views Answered 2022-09-01 13:21

Related Questions

Theoretical flame temperature of a fuel is that temperature which is attained, when the fuel is completely burnt 'using theoretical amount of air in?

1 Answers 5 Views

The inter-cooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p₁ = Intake pressure of air, p₂ = Inter-cooler pressure, and p₃ = Delivery pressure of air)?

1 Answers 8 Views

If p₁, is the pressure of air entering the L.P. cylinder and p₂ is the pressure of air leaving the L.P. cylinder (or inter-cooler pressure), then the ratio of cylinder diameters for a single acting, two stage reciprocating air compressor with complete intercooling is given by (where D₁ = Dia. of L.P. cylinder, and D₂ = Dia. of H.P. cylinder)?

1 Answers 6 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.?

1 Answers 4 Views

The critical pressure ratio is given by (where p₁ = Initial pressure of steam, and p₂ = Pressure of steam at throat or critical pressure)?

1 Answers 4 Views

The indicated power of a four stroke engine (in watts) is equal to (where P = Mean effective pressure in N/m², L = Length of stroke in metres, A = Cross-sectional area of the piston in m², and N = Speed of the engine in revolutions per second (r.p.s)?

1 Answers 4 Views

Effectiveness factor (E) of a catalyst pellet is defined as, E = (actual rate within pore of catalyst/rate if notsnowed by pore diffusion) Effectiveness factor for a first order reaction is given by (where, T = Thiele modulus)?

1 Answers 5 Views

The percentage slip in a reciprocating pump set is given by the % of (where, Q₁ = actual discharge Q₂ = theoretical discharge)?

1 Answers 5 Views

Co-efficient of discharge (Cd) is defined as actual discharge/theoretical discharge and is equal to Cc . Cv; where Cc = Co-efficient of contraction and Cv = co-efficient of velocity. Cd of an orifice is usually about?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)