Discharge (Q) of a centrifugal pump is given by (where D = Diameter of impeller at inlet, b = Width of impeller at inlet, and Vf = Velocity of flow at inlet)?

Q = π.D.Vf
Q = π.b.Vf
Q = π.D.bf.V
Q = D.b.Vf

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

4 views Answered 2022-09-01 13:21

Related Questions

A centrifugal pump will start delivering liquid only when the pressure rise in the impeller is equal to the?

1 Answers 4 Views

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)?

1 Answers 6 Views

Discharge of a centrifugal pump is (where N = Speed of the pump impeller)?

1 Answers 6 Views

The critical depth for a channel is given by (where q = Unit discharge (discharge per unit width) through the channel)?

1 Answers 6 Views

The depth ‘d’ below the free surface at which the point velocity is equal to the average velocity of flow for a uniform laminar flow with a free surface, will be (where D is the depth of flow)?

1 Answers 23 Views

The percentage slip in a reciprocating pump set is given by the % of (where, Q₁ = actual discharge Q₂ = theoretical discharge)?

1 Answers 5 Views

Co-efficient of discharge (Cd) is defined as actual discharge/theoretical discharge and is equal to Cc . Cv; where Cc = Co-efficient of contraction and Cv = co-efficient of velocity. Cd of an orifice is usually about?

1 Answers 5 Views

Which is the correct relationship for a centrifugal pump (where, D = Impeller diameter, inches H = Head developed, ft of liquid pumped N = Speed of pump, rpm)?

1 Answers 5 Views

The process, which causes the air to enter the impeller blades of a centrifugal compressor at ________ velocity (without effecting the mass of air to flow and velocity of flow) is known as prewhirl.?

1 Answers 7 Views

The most economical channel section for the fluid flow is the one for which the discharge is maximum for a given cross-sectional area. Vertical velocity distribution in an open channel for laminar flow can be assumed to be?

1 Answers 5 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)