Discharge of a centrifugal pump is (where N = Speed of the pump impeller)?

Directly proportional to N
Inversely proportional to N
Directly proportional to N²
Inversely proportional to N²

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 1

Let'

6 views Answered 2022-09-01 13:21

Related Questions

A centrifugal pump will start delivering liquid only when the pressure rise in the impeller is equal to the?

1 Answers 4 Views

In centrifugal pumps, cavitation occurs, when pressure of the impeller eye or vane becomes?

1 Answers 4 Views

Height of liquid in agitation tank is normally maintained equal to the tank diameter. However, if the tank is too tall and a large liquid hold up is desired, then two or more impellers mounted on the same shaft may be used. The clearance between the tank bottom and the bottom most impeller should be about (where, D = impeller diameter)?

1 Answers 6 Views

The discharge of a double acting reciprocating pump is (where L = Length of stroke, A = Cross-sectional area of piston, and N = Speed of crank in r.p.m.)?

1 Answers 5 Views

The discharge through a small rectangular orifice is given by (where Cd = Coefficient of discharge for the orifice, a = Cross-sectional area of the orifice, h = Height of the liquid above the centre of the orifice)?

1 Answers 5 Views

Discharge (Q) of a centrifugal pump is given by (where D = Diameter of impeller at inlet, b = Width of impeller at inlet, and Vf = Velocity of flow at inlet)?

1 Answers 4 Views

The percentage slip in a reciprocating pump set is given by the % of (where, Q₁ = actual discharge Q₂ = theoretical discharge)?

1 Answers 5 Views

Co-efficient of discharge (Cd) is defined as actual discharge/theoretical discharge and is equal to Cc . Cv; where Cc = Co-efficient of contraction and Cv = co-efficient of velocity. Cd of an orifice is usually about?

1 Answers 5 Views

Which is the correct relationship for a centrifugal pump (where, D = Impeller diameter, inches H = Head developed, ft of liquid pumped N = Speed of pump, rpm)?

1 Answers 5 Views

The process, which causes the air to enter the impeller blades of a centrifugal compressor at ________ velocity (without effecting the mass of air to flow and velocity of flow) is known as prewhirl.?

1 Answers 7 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)