The frictional torque transmitted in a conical pivot bearing, considering uniform pressure, is (where R = Radius of shaft and $$\alpha $$ = Semi-angle of the cone)?

$$\frac{1}{2}\mu {\text{WRcosec}}\alpha $$
$$\frac{2}{3}\mu {\text{WRcosec}}\alpha $$
$$\frac{3}{4}\mu {\text{WRcosec}}\alpha $$
$$\mu {\text{WRcosec}}\alpha $$

LohaHridoy

6 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

6 views Answered 2022-09-01 13:21

Related Questions

When the addenda on pinion and wheel is such that the path of approach and path of recess are half of their maximum possible values, then the length of the path of contact is given by (where r = Pitch circle radius of pinion, R = Pitch circle radius of wheel and $$\varphi $$ = Pressure angle)?

1 Answers 14 Views

When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be _________ the bearing modulus.?

1 Answers 4 Views

The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the bearing and R = Radius of bearing surface)?

1 Answers 5 Views

The frictional torque transmitted in a flat pivot bearing, assuming uniform wear, is (Where μ = Coefficient of friction, W = Load over the bearing, R = Radius of bearing)?

1 Answers 5 Views

The natural frequency of free torsional vibrations of a shaft is equal to (where q = Torsional stiffness of the shaft and $$I$$ = Mass moment of inertia of the disc attached at the end of a shaft)?

1 Answers 6 Views

The radius of a friction circle for a shaft rotating inside a bearing is (where r = Radius of shaft and $$\tan \varphi $$ = Coefficient of friction between the shaft and bearing)?

1 Answers 15 Views

The torque transmitted by a solid shaft of diameter (D) is (where $$\tau $$ = Maximum allowable shear stress)?

1 Answers 6 Views

The torque required to overcome viscous resistance of a footstep bearing is (where μ = Viscosity of the oil, N = Speed of the shaft, R = Radius of the shaft, and t = Thickness of the oil film)?

1 Answers 10 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

The property of a bearing material which has the ability to accommodate shaft deflections and bearing inaccuracies by plastic deformation without excessive wear and heating, is known as?

1 Answers 6 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)