The ratio of the driving tensions for V-belts is __________ times that of flat belts.(Where β = Semi-angle of the groove)?

sinβ
cosβ
cosecβ
secβ

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

Let'

4 views Answered 2022-09-01 13:21

Related Questions

When a wave is incident from the more dense into a less dense medium at an angle equal to or exceeding the critical angle, the wave suffers total internal __________ .?

1 Answers 11 Views

A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will?

1 Answers 11 Views

The frictional torque transmitted in a conical pivot bearing, considering uniform pressure, is (where R = Radius of shaft and $$\alpha $$ = Semi-angle of the cone)?

1 Answers 6 Views

In a band and block brake, the ratio of tensions on tight side and slack side of the band is (where $$\mu $$ = Coefficient of friction between the blocks and the drum, $$\theta $$ = Semi-angle of each block subtending at the center of drum and n = Number of blocks)?

1 Answers 4 Views

A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)?

1 Answers 5 Views

In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where $$\mu $$ = Coefficient of friction between the blocks and the drum, $$\theta $$ = Semi-angle of each block subtending at the centre of drum and n = Number of blocks)?

1 Answers 4 Views

For a shoe brake, the equivalent coefficient of friction is equal to (where $$\mu $$ = Actual coefficient of friction and $$\theta $$ = Semi-block angle)?

1 Answers 5 Views

The relation among various mass transfer co-efficients (M.T.C) for ideal gases is given by (where, Kc & Km are M.T.C. for equimolar counter diffusion with concentration & mole fraction respectively as the driving force. and, Kp = M.T.C. for diffusion of a gas through a stagnant inert gas with pressure as driving force.)?

1 Answers 4 Views

Directions : Each of the following question consists of a statement followed by two arguments I and II. You have to decide which of the arguments is a STRONG arguments and which is a WEAK Argument. Statement : Should there be a world government Arguments : I. Yes. It will help in eliminating tensions among the nations. II. No. Then, only the developed countries will dominate in the government.?

1 Answers 4 Views

If the angle of projection is double the angle of inclination (α) of the plane on which particle is projected, the ratio of times of flight up the inclined plane and down the inclined plane, will be?

1 Answers 9 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)