In a differential band brake as shown in the below figure, if the length OB is greater than OA, then the force P at C should act in the downward direction.?

Yes
No
Unpredictable
None of these

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

5 views Answered 2022-09-01 13:21

Related Questions

According to Fleming's right-hand rule for finding the direction of induced e.m.f., when middle finger points in the direction of induced e.m.f., forefinger will point in the direction of?

1 Answers 5 Views

The motion between a pair when limited to a definite direction, irrespective of the direction of force applied, is known as?

1 Answers 5 Views

The sequence in which the force is transmitted through a brake system when the brake pedal is depressed is?

1 Answers 7 Views

Study the following statements.i) The displacement method is more useful when degree of kinematic indeterminacy is greater than the degree of static indeterminacy.ii) The displacement method is more useful when degree of kinematic indeterminacy is less than the degree of static indeterminacy.iii) The force method is more useful when degree of static indeterminacy is greater than the degree of kinematic indeterminacy.iv) The force method is more useful when degree of static indeterminacy is less than the degree of kinematic indeterminacy.The correct answer is?

1 Answers 7 Views

A direction pole was situated on the crossing. Due to an accident the pole turned in such a manner that the pointer which was showing East, started showing South. One traveler went to wrong direction thinking to be West. In what direction actually he was traveling?

1 Answers 4 Views

For the brake to be self locking, the force P at C shown in the below figure, should?

1 Answers 4 Views

In a framed structure, as shown in the below figure, the force in the member AB is __________ the force in member AC.?

1 Answers 10 Views

In a band and block brake, the ratio of tensions on tight side and slack side of the band is (where $$\mu $$ = Coefficient of friction between the blocks and the drum, $$\theta $$ = Semi-angle of each block subtending at the center of drum and n = Number of blocks)?

1 Answers 4 Views

In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where $$\mu $$ = Coefficient of friction between the blocks and the drum, $$\theta $$ = Semi-angle of each block subtending at the centre of drum and n = Number of blocks)?

1 Answers 4 Views

The brake power (B.P.) of the engine is given by (where W = Brake load or dead load in newtons, l = Length of arm in meters, N = Speed of engine in r.p.m., S = Spring balance reading in newtons, D = Dia. of brake drum in meters, and d = Dia. of rope in meters)?

1 Answers 14 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)