Heat of transition is the heat evolved or absorbed, when a substance is converted from?

Vapor to liquid
Vapor to solid
Solid to liquid
One allotropic form to another allotropic form

LohaHridoy

5 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 4

Let'

5 views Answered 2022-09-01 13:21

Related Questions

Messages from one computer terminal can be sent to another by using data networks. The message to be sent is converted to an electronic digital signal, transmitted via a cable, telephone or satellite and then converted back again at the receiving end. What is this system of sending messages called?

1 Answers 5 Views

When an alternating current passes through an ohmic resistance the electrical power converted into heat is?

1 Answers 6 Views

The change of entropy, when heat is absorbed by the gas, is?

1 Answers 4 Views

The cast iron when heated to red heat with powdered red haematite in an oven for increasing its toughness, is converted to?

1 Answers 4 Views

Which of the following property defines when the transition will start and it allows a transition to begin execution some some period of time from when it is applied?

1 Answers 4 Views

The heat absorbed or rejected by the working substance is given by (where ds = Increase or decrease of entropy, T = Absolute temperature, and dQ = Heat absorbed or rejected)?

1 Answers 4 Views

Sensible heat factor is given by (where S.H. = Sensible heat, and L.H. = Latent heat)?

1 Answers 7 Views

Thermal diffusivity of a substance is given by (where h = Thermal diffusivity, ρ = Density of substance, S = Specific heat, and k = Thermal conductivity)?

1 Answers 6 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

Fouling factor for a heat exchanger is given by (where, U₁ = heat transfer co-efficient of dirty surface U₂ = heat transfer co-efficient of clean surface)?

1 Answers 9 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)