The edge of a steel plate cut by oxygen cutting will get hardened when the carbon content is?

Less than 0.1 percent
Less than 0.3 percent
More than 0.3 percent
Anywhere between 0.1 to 1 percent

LohaHridoy

4 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 3

The edge of a steel plate cut by oxygen cutting will get hardened when the carbon content is More than 0.3 percent

4 views Answered 2022-09-01 13:21

Related Questions

When the cutting edge of the tool is dull, then during machining?

1 Answers 6 Views

In metal cutting, use of low feeds and high cutting speeds is desired when the objective is?

1 Answers 4 Views

A composite wall consists of two plates A and B placed in series normal to the flow of heat. The thermal conductivities are kA and kB and the specific heat capacities are CPA and CPB for plates A and B respectively. Plate B has twice the thickness of plate A. At steady state, the temperature difference across plate A is greater than that across plate B, when?

1 Answers 9 Views

Steel will respond to hardening by heat treatment processes, only when the minimum carbon content in it is __________ percent.?

1 Answers 5 Views

A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)?

1 Answers 5 Views

In order to avoid tearing of the plate at an edge, the distance from the centre line of the rivet hole to the nearest edge of the plate should be equal to (where d = Diameter of rivet hole)?

1 Answers 5 Views

In order to avoid tearing off the plate at an edge, the distance from the center of the rivet hole to the nearest edge of the plate (i.e. margin) should be (where d = Diameter of rivet hole in mm)?

1 Answers 4 Views

In the laminar boundary layer flow over a flat plate, the ratio (δ/x) varies as :(where, 'δ' is the boundary layer thickness and 'x' is the distance from the leading edge in the direction of flow).?

1 Answers 5 Views

In a plain milling cutter, the portion of the gash adjacent to the cutting edge on which the chip impinges is called?

1 Answers 4 Views

The material which can be best cut with oxygen cutting process is?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)