The ratio of exit pressure to inlet pressure for maximum mass flow rate per unit area of steam through a nozzle when steam is initially dry saturated is?

0.6
0.578
0.555
0.5457

LohaHridoy

9 views

2025-01-04 04:42

1 Answers

AhmedNazir

Answer: Option 2

Let'

9 views Answered 2022-09-01 13:21

Related Questions

The ratio of exit pressure to inlet pressure of maximum mass flow rate per area of steam through a nozzle when steam is initially superheated is?

1 Answers 6 Views

The ratio of the actual mass of water vapour in a unit mass of dry air to the mass of water vapour in the same mass of dry air when it is saturated at the same temperature and pressure, is called?

1 Answers 5 Views

When the inlet pressure of steam is equal to the exit pressure, then?

1 Answers 4 Views

The rate of discharge through the nozzle __________ when the exit pressure is gradually reduced.?

1 Answers 4 Views

When the back pressure of a nozzle is below the designed value of pressure at exit of nozzle, the nozzle is said to be?

1 Answers 4 Views

When the nozzle operates with the maximum mass flow, the nozzle is said to be?

1 Answers 4 Views

Fourier's law of heat conduction is (where Q = Amount of heat flow through the body in unit time, A = Surface area of heat flow, taken at right angles to the direction of heat flow, dT = Temperature difference on the two faces of the body, dx = Thickness of the body, through which the heat flows, taken along the direction of heat flow, and k = Thermal conductivity of the body)?

1 Answers 4 Views

Discharge (Q) of a centrifugal pump is given by (where D = Diameter of impeller at inlet, b = Width of impeller at inlet, and Vf = Velocity of flow at inlet)?

1 Answers 4 Views

Relative humidity is given by (where pv = Partial pressure of water vapour, pb = Barometric pressure, ps = Pressure of saturated air, pd = Pressure at dry bulb temperature, pw = Saturation pressure corresponding to wet bulb temperature, and μ = Degree of saturation)?

1 Answers 5 Views

The velocity of steam leaving the nozzle (V) is given by (where K = Nozzle coefficient or nozzle efficiency, and hd = Enthalpy or heat drop during expansion of steam in a nozzle)?

1 Answers 4 Views

এক্সাম দিয়ে মেধা যাচাই করুন

Job Preparation (1125)

Admission (754)

এসএসসি (10)

এইচএসসি (5)