Bissoy.com
Doctors Medicines MCQs Q&A

The important factor to be considered while selecting a bearing is

The important factor to be considered while selecting a bearing is Correct Answer All option is correct

Concept:

Important factors to be considered:

  • Dimensional limitation: Allowable space for bearings is generally limited.
  • Applied loads: The characteristic, magnitudes & direction of loads is important.
  • Rotational speed: It depends upon bearing type, size, tolerance, cage type, load lubrication & cooling condition,
  • Bearing tolerances
  • Rigidity
  • Misalignment of inner & outer races
  • Noise & torque levels
  • Installation of disassembly.

Related Questions

Which of the following are the functions of lubrication in a bearing unit ? 1. To protect the bearing components from corrosion. 2. To absorb heat from the bearing unit. 3. To carry heat away from the bearing unit. Select the correct answer using the code given below
Consider the following two statements regarding Bearing stiffeners provided at the location of a concentrated load: 1. Bearing stiffeners have to resist bearing and buckling loads. 2. Bearing area and the area resisting buckling load are the same. Which of the above statements is/are correct ?
A rotor which is balanced statically but not dynamically is supported on two bearings L apart and at high speed of the rotor, reaction on the left bearing is R. The right side of the bearing is shifted to a new position 2L apart from the left bearing. At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will
Which of the following are the general design requirements of retaining wall? 1. The factor of safety against sliding should be at least 1.5 2. The factor of safety against over-turning should be at least 2.0 3. The bearing pressure at toe should be less than the bearing capacity of the soil 4. The length of retaining wall to be cast in one go should not exceed 10 m otherwise cracks may develop 
Statement (I): The journal while rotating inside a bearing automatically shifts its centre to one side and thus the journal is eccentric inside the bearing. Statement (II): The wedge shape of oil film gives rise to thin-film lubrication, which is considered as stable lubrication.
The frictional torque transmitted in a flat pivot bearing, considering uniform wear, is (where μ = Coefficient of friction, W = Load over the bearing and R = Radius of bearing surface)
When the bearing is subjected to large fluctuations of load and heavy impacts, the bearing characteristic number should be _________ the bearing modulus.
If p = bearing pressure on projected bearing area, Z = absolute viscosity of lubricant and N = speed of journal, then the bearing characteristic number is given by
Consider the following statements: In a plate girder 1. Bearing stiffeners are designed for bearing forces and they must also be checked for safety against compressive forces. 2. The length of any staggered intermittent fillet weld should not be less than 10 times the thickness of the stiffener. 3. Bearing stiffeners must be provided at the point of maximum bending moment. Which of the above statements are correct?
In a compass survey work of an open traverse ABCDE shown in the figure, the bearing of the first line AB observed was not clearly written in the field. The observed bearing of the last line DE was recorded as S36°40’E. If the deflection angles are 31°50' (right) at D, 42°30' (right) at C, and 18°20' (left) at B. calculate the bearing of the first line AB.