Bissoy.com
Doctors Medicines MCQs Q&A

A canal fall is a control structure

A canal fall is a control structure Correct Answer The location of which is independent of the command to be served

Canal Fall:

It is a structure constructed across a canal to allow the lowering of the water level of the canal and dissipate the surplus energy liberated from the falling water. The location of canal fall is independent of the command to be served

The location of Canal fall depends upon:

i. Topography

ii. A possibility of combining with a bridge or a regulation

iii. Economic consideration

Related Questions

Which one is incorrect? 1. Kumabaram Lift Canal-Older name - Nohar Sohwa Lift Canal. 2. Kawar sen Lift Canal-Older name - Lunaksar Lift Canal. 3. Panna Lal Lift Canal - Older name - Gajner Lift canal. 4. Veer Tejaji Lift Canal-Older name - Bagdsar.
Which of the following canals were constructed as a part of the Triple Canal Project that began in 1905? 1. Upper Bari Doab Canal 2. Upper Jhelum Canal 3. Upper Chenab Canal 4. Lower Bari Doab Canal
Which of the following is/are the advantages of using a control chart for inspection? (i) A control chart indicates whether the process is in control or out of control. (ii) A control chart determines process variability. (iii) A control chart ensures product quality. (iv) Scrap or percentage reduction can be reduced by taking the necessary actions in time against the warnings indicated by control charts. (v) Control charts build up the reputation of the organization through customer’s satisfaction. (vi) The control chart can detect the unusual variations taking place in a process.
Consider the following statements. I. Possibility of combining some other structure with a fall eg. regulator, road bridge etc. II. Cutting and filling are required below and above the fall should not be necessarily equal. III. The command should not be reduced due to the lowering of F.S.L and the fall may be located below the outlets. Which of the following statement is correct for site selection of a fall?
The following statements (C1, C2, C3, C4) pertain to the characteristics of different type of canals. Which of the following statements is/are correct? C1: A contour canal can irrigate command areas on both the banks. C2: It is possible to construct a contour canal with banks on one side only. C3: In the case of a ridge canal, the number of cross drainage works are maximum. C4: Side slope canal is aligned roughly at right angles to the ground contours.
Which of the following is/are true for the Narmada Main Canal of Sardar Sarovar Project? (i) Narmada Main Canal is a contour canal. (ii) It is the largest lined irrigation canal in the world. (iii) It has a capacity to flow 40000 cusecs at its head.
Which of the following is the correct statement? 1. Narmada Canal project is between Gujarat, Rajasthan, Maharastra. 2. Narmada Canal project is also known as MARWAR KI BHAGIRATHI. 3. Narmada Canal project totally based on the sprinkler system. 4. Narmada Canal project's total length is 432 km.
Which of the following statement is/are incorrect about Canal Irrigation? Canal irrigation provides safety from droughts and it brings fertile sediments to the fields. The main concentration of canal irrigation is in the southern plains. The percentage of canal irrigation area to total irrigated area in the country has fallen from about 40% in 1950-51 to less than 25% at present. Select the incorrect code from below.
Which of the following statements is/are true about the Eastern Yamuna Canal? I-Eastern Yamuna Canal is the oldest canal in Uttar Pradesh. II-It was built in the year of 1830 III-Work of this canal was started by Shah Jahan
Which of the following is NOT correctly matched? (Canal Project) (Location) A. Ghataprabha Canal Project - Karnataka B. Ukai Canal Project - Gujarat C. Nira Canal Project - Maharashtra D. Jawai Project - Tamil Nadu