Bissoy.com
Doctors Medicines MCQs Q&A

Ionization within a P-N junction causes a layer on each side of the barrier called the

Ionization within a P-N junction causes a layer on each side of the barrier called the Correct Answer Depletion region

  • The depletion region is formed when carriers from one side of junction cross the junction and move to another side
  • This movement of charge carriers leave ionized impurities behind near the junction
  • The region near the junction, devoid of charge carriers, but consisting of ionized impurities is called depletion region (depleted of charge carriers)

Related Questions

Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.
Consider the following statements regarding the formation of P-N junctions: 1. Holes diffuse across the junction from P-side to N-side. 2. The depletion layer is wiped out. 3. There is a continuous flow of current 4. A barrier potential is set up across the junction.  Which of the above statement are correct?
Assertion (A): A p-n junction diode with low junction depth can be used as a solar cell when illuminated by suitable light (wavelength) at the top thin layer above the junction. Reason (R): A p-n junction diode under no condition can be used as a solar cell. It can be used only as a light-emitting diode for optoelectronic applications.
Electrospray ionization MS and matrix-assisted laser desorption ionization (MALDI) MS only differ in the ionization procedure used.
Match Old name with the new name. Old Name  New Name I. Allahabad Junction a) Pandit Deen Dayal Upadhyaya Junction II. Manduadih railway station b) Prayagraj Junction III. Mughalsarai junction c) Prayagraj Rambaug Railway station IV. Allahabad City railway station d) Banaras Railway Station Choose the correct code given below:
Sourab hires a car at junction A and drives 16 km towards north. He takes a right turn and drives 30 km to reach a bus stand. He now drives 10 km after taking a left turn to reach a petrol bunk. Finally, he takes a left turn and drives 30 km, and stops at Junction B. How far is junction A with respect to junction B?
A transistor is used in common emitter mode as an amplifier. Then a. The base-emitter junction is forward biased b. The base-emitter junction is reverse biased  c. The input signal is connected in series with the voltage applied to the base-emitter junction  d. The input signal is connected in series with the voltage applied to bias the base-collector junction Which of the following statement is true?
For transistor action (a) Base, emitter, and collector regions should have similar size and doping concentrations. (b) The base region must be very thin and lightly doped. (c) The emitter-base junction is forward biased and the base-collector junction is reverse biased. (d) Both the emitter-base junction as well as the base-collector junction are forward biased. Which one of the following pairs of statements is correct?
Which of the following conditions must be satisfied for a transistor to be in saturation? 1. Its collector to base junction should be under forward bias 2. Its collector to base junction should be under reverse bias 3. Its emitter to base junction should be under reverse bias 4. Its emitter to base junction should be under forward bias Which of the above conditions are correct?
One side of a triangle and a rectangle is the same. The third vertex of the triangle lies on the midpoint of the rectangle side opposite the common side. The rectangle sides are in the ratio 2 : 3 and the common side is the longer side of the rectangle.  What is the sin value of the angle between the common side and the equal side of the triangle?