Bissoy.com
Doctors Medicines MCQs Q&A

The electrical switches are put in the:

The electrical switches are put in the: Correct Answer Live wire

  • Electrical switches must be fitted into the live wire so that opening it will disconnect the appliance from the high voltage live wire
  • If the switch is placed in the neutral wire, the electrical appliance is still connected to the high voltage live wire even when the switch is opened

Related Questions

To configure the VLAN trunking protocol to communicate VLAN information between two switches, what two requirements must be met?
1. Each end of the trunk link must be set to the IEEE 802.1e encapsulation.
2. The VTP management domain name of both switches must be set the same.
3. All ports on both the switches must be set as access ports.
4. One of the two switches must be configured as a VTP server.
5. A rollover cable is required to connect the two switches together.
6. A router must be used to forward VTP traffic between VLANs.
A 3 - ϕ CSI used for the speed control of an induction motor is to be realized using MOSFET switches as shown below. Switches S1 to S6 are identical switches. The proper configuration for realizing switches S1 to S6 is
Match the following Device Conversion of Energy (a) Windmill (i) Chemical Energy to electrical energy (b) Bulb (ii) Kinetic Energy to Electrical Energy (c) Electrical Cell (iii) Sound Energy to Electrical energy (d) Microphone (iv) Electrical Energy to Light Energy
Rohan put 9 cards on a table, some face up and the rest face down. How many were put face down? A. Rohan put an even number of the cards face up. B. Rohan put twice as many of the cards face up as he put face down. Select the correct answer from the options given below:
Some small cubes of same height 7 cm but variable length and width are put inside a large cuboid of height 21 cm. Length and width of cuboid is 32 cm and 24 cm, respectively. Small cubes are put such that cubes at the bottom most layer is of similar base area; second layer contains all the cubes of similar base area and third layer have all the cubes of similar base area. Which of the following statement(s) given below is / are TRUE? A: If side of each small cubes at bottom most layer is 8 cm, then maximum number of small cubes that can be put at bottom most layer is 12. B: If maximum of 48 cubes can be put at second layer, then side of each cube at second layer is 6 cm. C: If side of each small cubes at third layer is 1.6 cm, then maximum number of small cubes that can be put at third layer is 300.
What does hydropower change A. Kinetic energy to electrical energy B. Mechanical energy from electrical energy C. Chemical energy to electrical energy D. Wind energy to electrical energy
Which type of fire extinguishers are used to put out electrical fires from electrical components or energized electrical equipment?
Each material circumstance appearing in evidence against the accused must be put to the accused specifically, distinctly and separately. In this context, the propositions are
1. Failure to put the material evidence to the accused always vitiates the trial
2. Failure to put the material evidence amounts to a serious irregularity which can not be cured and vitiates the trial, if it has prejudiced the accused.
3. Failure to put the material evidence is not considered to services & is curable if infact no failure of justice has occasioned to the accused.
Now which of the following is correct
You have two switches connected together with two crossover cables for redundancy, and STP is disabled. Which of the following will happen between the switches?
A four-person crew from Classic Colors is painting Mr. Field's house. Michael is painting the front of the house. Ross is in the alley behind the house painting the back. Jed is painting the window frames on the north side, Shawn is on the south. If Michael switches places with Jed, and Jed then switches places with Shawn, where is Shawn?