Bissoy.com
Doctors Medicines MCQs Q&A

Wound dressing is done by using

Wound dressing is done by using Correct Answer Medical and surgical asepsis

Concept:

  • An open wound has a higher risk of getting an infection.
  • Infection is spread through hand contamination.
  • Therefore, the wound dressing is done by using surgical asepsis.
  • Medical Asepsis can be used for dressings of Minor injuries like abrasions
  • The first aid should be done by following medical Asepsis
  • Two types of aseptic techniques-
    • Medical asepsis (clean technique):
      • Practices that kill certain microorganisms to stop them from spreading.
      • Medical asepsis is mainly used routinely.
    • Surgical asepsis (sterile techniques):
      • Practices that completely kill and eliminate microorganisms.
      • Wound dressing is done by using Surgical asepsis.
      • If dealing with an open wound or cavity then should use surgical asepsis to maintain aseptic techniques.

Explanation:

  • Instructions for surgical asepsis of wound dressing:
    • Explain the procedure.
    • Maintain privacy.
    • Wash hands and collect the articles near-patient the bedside.
    • Wash hands through surgical asepsis.
    • Maintain sterility by wearing sterile gloves and a mask, if required.
    • Keep sterile and unsterile fields separate.
    • Complete the procedure following aseptic techniques.

Related Questions

In the question below, which one of the given responses would be a meaningful order of the following words? 1. Clean and Sanitize your hands. 2. Apply the new dressing. 3. Let the wound dry. 5. Bring the wound care items. 4. Clean the wound.
The figure below shows a schematic of a water droplet placed on the surfaces of two mineral P and Q.
Mineral Dressing in Metallurgy mcq question image
Given this information, pick the correct statement from the following:
The figure below shows the cumulative size distribution of particles of a crushed mineral. 10 kg of this material is first passed through a sieve of size 400 micron and then through a sieve of size 300 micron. The weight of mineral (in kg ) that is retained on the 300 micron sieve is . . . . . . . .
Mineral Dressing in Metallurgy mcq question image
For a four pole, 16 slot armature with two coil-side/slot having lap connected progressive winding has single turn coils. The same machine is then wave wound, the emf induced in the lap wound dc machine to that of wave wound will be ________
What technique should be adopted while dressing the wound?
Transcyte® is a non-living wound dressing produced by Advanced Tissue Sciences, Inc.
After a storm the rescue team is searching for injured people. A nurse on the team discovers a victim lying next to a broken natural gas line. The victim is not breathing and is bleeding heavily from a leg wound. How should the nurse proceed? Place care in order of their priority. 1. Take the victim’s vital signs. 2. Start rescue breathing immediately. 3. Apply surface pressure to the foot wound. 4. Remove the victim from the immediate vicinity. 5. Transport the victim to the hospital immediately.
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of flux/pole?
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. What is the value of induced emf?
A 4-pole Dc wound machine is lap wound with 400 conductors. The pole shore is 20 cm long and average flux density over one-pole pitch is 0.4 T, the armature diameter being 30 cm. Here, motor is drawing 25 A current at 1500 rpm. What is the available torque (N-m) at shaft?