Related Questions

The moment to bridge the chasms that divide us has come" Why do the word bridge the chasms have been used ---
ক to eliminate difference
খ to keep up the brotherhood
গ to maintain religious bond
ঘ to foster humanity
The moment to bridge the chasms that divide us has come. Here the underlined word means-
ক Hollowness
খ Cleft
গ Dept
ঘ Joint
When a shaft is subjected to combined twisting moment (T) and bending moment (M), then the equivalent twisting moment is equal to
ক $$\frac{1}{2}\sqrt {{{\text{M}}^2} + {{\text{T}}^2}} $$
খ $$\sqrt {{{\text{M}}^2} + {{\text{T}}^2}} $$
গ $$\frac{1}{2}\left( {{\text{M}} + \sqrt {{{\text{M}}^2} + {{\text{T}}^2}} } \right)$$
ঘ $${\text{M}} + \sqrt {{{\text{M}}^2} + {{\text{T}}^2}} $$
For a given stress, the ratio of moment of resistance of a beam of square cross-section when placed with its two sides horizontal to the moment of resistance with its diagonal horizontal, is
ক $$\frac{1}{2}$$
খ 1
গ $$\frac{1}{{\sqrt 2 }}$$
ঘ $$\sqrt 2 $$
Mass moment of inertia of a thin rod about its one end is ___________ the mass moment of inertia of the same rod about its mid-point
ক Same as
খ Twice
গ Thrice
ঘ Four times
The yield moment of a cross section is defined as the moment that will just produce the yield stress in
ক The outer most fibre of the section
খ The inner most fibre of the section
গ The neutral fibre of the section
ঘ The fibre everywhere
If W is total load per unit area on a panel, D is the diameter of the column head, L is the span in two directions, then the sum of the maximum positive bending moment and average of the negative bending moment for the design of the span of a square flat slab, should not be less than
ক $$\frac{{{\text{WL}}}}{{12}}{\left( {{\text{L}} - \frac{{2{\text{D}}}}{3}} \right)^2}$$
খ $$\frac{{{\text{WL}}}}{{10}}{\left( {{\text{L}} + \frac{{2{\text{D}}}}{3}} \right)^2}$$
গ $$\frac{{{\text{WL}}}}{{10}}{\left( {{\text{L}} - \frac{{2{\text{D}}}}{3}} \right)^2}$$
ঘ $$\frac{{{\text{WL}}}}{{12}}{\left( {{\text{L}} - \frac{{\text{D}}}{3}} \right)^2}$$
In moment resistant connections, the moment resistance of riveted connection depends upon
ক Shear in rivets
খ Compression in rivets
গ Tension in rivets
ঘ Strength of rivets in bearing
The ratio of the moment of inertia of a rectangle about its centroidal axis to the moment of inertia about its base, is
ক $$\frac{1}{4}$$
খ $$\frac{1}{2}$$
গ $$\frac{3}{4}$$
ঘ $$2$$
A rectangular magnet of magnetic moment M is cut into two piece of same length, the magnetic moment of each piece will be
ক M
খ $$\frac{{\text{M}}}{2}$$
গ 2 M
ঘ $$\frac{{\text{M}}}{4}$$

Next steps