Assertion (A) Bending a wire does not effect electrical resistance.
Reason (R) Resistance wire is proportional to resistivity of materials.

Assertion (A) Bending a wire does not effect electrical resistance.
Reason (R) Resistance wire is proportional to resistivity of materials. Correct Answer Both A and R are true, but R is not the correct explanation of A

Bissoy MCQ

Related Questions

For better resistance welding, the metal must have
P. high electrical resistivity and low melting point
Q. high thermal conductivity
R. high electrical resistivity and high melting point
S. low thermal conductivity
Variation of electrical resistivity $$\rho $$ with temperature T of three solids is sketched (on different scales) in the figure, as curves P, Q and R.
Which one of the following statements describes the variations most appropriately?
Solid State Physics mcq question image
How is the degree of emulsion polymerization related to the monomer concentration, and the rate of radical generation, Ri? , inversely proportional to Ri b) inversely proportional to Ri, directly proportional to . c) directly proportional to Ri, independent of . d) directly proportional to , independent of Ri
A telephone switchboard 100 pair cable can be made up with either enameled wire or tinned wire. There will be 400 soldered connections. The cost of soldering a connection on the enameled wire will be P 1.65 on the tinned wire, it will be P 1.15. A 100- pair cable made up with enameled wire cost P 0.55 per linear foot and those made up of tinned wire cost P 0.75 per linear foot. Determine the length of cable run in feet so that the cost of each installation would be the same.
An elevator is assembled to raise equipment to a height of 22m. It is estimated that maximum weight of the material to be raised is 4.9kN. It is observed acceleration in such cases is 1.2m/s².10mm diameter wire ropes with fibre core are used. The tensile designation of the wire is 1500.Number of rope wires is assumed to be 2. Number of rope wires is assumed to be 2. Calculate the total load on wire rope neglecting the bending load if weight of 50m wire is 18kg.
The bending moment at a section tends to bend or deflect the beam and the internal stresses resist its bending. The resistance offered by the internal stresses, to the bending, is called
In the electrical resistivity method, the unit of resistivity is ohms-cm.
Strain gage uses an electrical conductor wire, which when elastically stretched increases in length and reduces in diameter. Both these dimensional changes result in __________ in the electrical resistance of the wire.
A wire has the same resistance as the one given in the figure. Calculate its resistivity if the length of the wire is 10m and its area of cross section is 2m.
Compute the sheet resistance of a 0.17 µm thick Cu wire if resistivity of Cu wire is 1.7 µΩ-cm.