Related Questions

Pharmacists recently conducted a study with respect to the reasons their customers purchased eye drops to soothe eye dryness. Dry eyes were more frequently experienced by customers who wore contact lenses than by custorners who did not wear contact lenses. The pharmacists concluded that wearing contact lenses, by itself, can cause contact wearers to have dry eyes.
A An inherited condition can cause both weak eyesight and dry eyes
B Physical exertion causes dry eyes in many people who wear contact lenses.
C Most people who have dry eyes do not wear contact lenses.
D Most people who wear contact lenses do not have dry eyes.
Two circular dials of exactly the same size are mounted on a wall side by side in such a way that their perimeters touch at one point. Dial 1, which is on the left , spins clockwise around its center , and dial 2 , which is on the right spins counter clockwise around its center . (Assume that there is no friction at the point of contact between the dials.) Each dial is marked on its perimeter at three points that are at equale distances around the points arked ondial 1 are N, O, and P and the points marked on dial 2 are X, Y, and Z. If points O and Z are just meeting at the point of contact between the dials , and if dial 1 spins at the same speed as dial 2, what is the smallest number of revolutions of each dial that will bring O and Z together again?
A 1
B 2
C 3
D 4
If points P and X are just meeting at the point of contact between the dials , and if dial 2 spins at exactly double the speed of dial 1, which of the following pairs of contact ?
A N and Y
B N and Z
C O and X
D O and Z
If points P and Y are just meeting at the point of contact between the dials , and if dial 1 spins at exactly three time the speed of dial 2, which of the following pairs of points will be the next pair to meet at the point of contact?
A N and X
B N and Z
C O and Y
D P and Z
The rolling contact bearings as compared to sliding contact bearings have
A Low starting and low running friction except at very high speeds
B Accuracy of shaft alignment
C Small overall dimensions
D All of the above
Indirect contact heat exchangers are preferred over direct contact heat exchangers, because
A Heat transfer co-efficient are high
B There is no risk of contamination
C There is no mist formation
D Cost of equipment is lower
A semicircular disc rests on a horizontal surface with its top flat surface horizontal and circular portion touching down. The coefficient of friction between semi circular disc and horizontal surface is µ. This disc is to be pulled by a horizontal force applied at one edge and it always remains horizontal. When the disc is about to start moving, its top horizontal force will
A Remain horizontal
B Slant up towards direction of pull
C Slant down towards direction of pull
D None of the above
Contact lenses are worn in one's-
A cameras
B eyes
C shoes
D clothes
When the two elements of a pair have a surface contact when relative motion takes place and the surface of one element slides over the surface of the other, the pair formed is known as a
A lower pair
B higher pair
C self-closed pair
D force-closed pair
When the nature of contact between the elements of a pair is such that one element can turn about the other by screw threads, the pair is known as a
A Screw pair
B Spherical pair
C Turning pair
D Sliding pair

Next steps