Related Questions

Two shafts A and B are made of the same material. The diameter of shaft A is twice as that of shaft B. The power transmitted by the shaft A will be __________ of shaft B.
A Twice
B Four times
C Eight times
D Sixteen times
The e.m.f. generated by a shunt wound D.C. generator is E. Now while pole flux remains constant, if the speed of the generator is doubled, the e.m.f. generated will be
A $$\frac{{\text{E}}}{2}$$
B 2E
C Slightly less than E
D E
In a cross linked polymer, the monomeric units are linked together to constitute a three dimensional network. Which of the following is a cross-linked polymer?
A Bakelite (phenol formaldehyde)
B Polyester
C Polythene
D Nylon-6
The natural frequency of free torsional vibrations of a shaft is equal to (where q = Torsional stiffness of the shaft and $$I$$ = Mass moment of inertia of the disc attached at the end of a shaft)
A $$2\pi \sqrt {\frac{{\text{q}}}{I}} $$
B $$2\pi \sqrt {{\text{q}}I} $$
C $$\frac{1}{{2\pi }}\sqrt {\frac{{\text{q}}}{I}} $$
D $$\frac{1}{{2\pi }}$$
The radius of a friction circle for a shaft rotating inside a bearing is (where r = Radius of shaft and $$\tan \varphi $$  = Coefficient of friction between the shaft and bearing)
A $${\text{r}}\sin \varphi $$
B $${\text{r}}\cos \varphi $$
C $${\text{r}}\tan \varphi $$
D $$\frac{{\text{r}}}{2}\cos \varphi $$
The product of the tangential force acting on the shaft and its distance from the axis of the shaft (i.e. radius of shaft) is known as
A Bending moment
B Twisting moment
C Torsional rigidity
D Flexural rigidity
If Bashar can run around a ground four times in 20 minutes and Rahim can run around the same ground three times in 12 minutes, who can run around that ground more times in an hour, and how many times more can he run around ?
A Bashar, three times more
B Rahim , three times more
C They both go around 12 times
D Bashar, eight times more
High pressure steam is expanded adiabati-cally and reversibly through a well insulated turbine, which produces some shaft work. If the enthalpy change and entropy change across the turbine are represented by ΔH and ΔS respectively for this process:
A ΔH = 0 and ΔS = 0
B ΔH ≠ 0 and ΔS = 0
C ΔH ≠ 0 and ΔS ≠ 0
D ΔH = 0 and ΔS ≠ 0
In a linear polymer, the monomeric units are linked together to form long straight chains. The cross linked or branched chain polymers compared to linear polymers have higher
A Densities
B Melting point
C Tensile strength
D Hardness, rigidity & brittleness
The ratio of the indicated power to the shaft power or brake power of the motor or engine required to drive the compressor, is called
A Compressor efficiency
B Volumetric efficiency
C Isothermal efficiency
D Mechanical efficiency

Next steps