Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

At a stationary shop, it costs Tk. 185 for 4 gel-pen, 8 ball -point pens and 1 marker pen and Tk. 315 for 7 gel-pens, 15 ball point pens and 1 marker pen. What would be the cost of 1 gel-pen, 1 ball -point pen and 1 marker pen?
Which of the following command options are displayed when you use the Router# show frame-relay ? command?
1. dlci
2. neighbors
3. lmi
4. pvc
5. map
In a certain code language - "tnu sno pmp" is coded as "pen pencil eraser", "pmp ons ptmp" is coded as "eraser ruler marker", "ons unt ptmp" is coded as "sharpener. marker ruler" and "tnu unt sno" is coded as "sharpener. pencil pen". What is the code for "ptmp unt"? 
In a certain code language-"Marker is red" is written as "sty yu pno", "apples are red" is written as "pno ty omp", "Marker is also green "is written as "sty yu jky pso" and "bottles are green" is written as "ty pso png". Then what is the code for "Apples are also bottles"?
Consider the following statements:
1. Section 34 of Indian Penal Code requires two persons whereas Section 149 of Indian Penal Code require five persons.
2. Section 34 of Indian Penal Code requires common intention, whereas Section 149 of Indian Penal Code requires common object
3. Section 34 of Indian Penal Code and Section 149 of Indian Penal Code both require presence of a prior consent
4. Section 34 of Indian Penal Code and section 149 of Indian Penal Code. Both create specific offence
Which of the above statements are correct?
The code marker option does not create ______
Which of the following commands will display the current IP addressing and the layer 1 and 2 status of an interface?
1. show version
2. show protocols
3. show interfaces
4. show controllers
5. show ip interface
Which three commands can be used to check LAN connectivity problems on a router?
1. show interfaces
2. show ip route
3. tracert
4. ping
5. dns lookups
To enable EIGRP, which of the following would you use?
1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
2. Router1(config-if)# ipv6 router rip 1
3. Router1(config)# ipv6 router eigrp 10
4. Router1(config-rtr)# no shutdown
5. Router1(config-if)# ipv6 eigrp 10
You need to allow one host to be permitted to attach dynamically to each switch interface. Which two commands must you configure on your catalyst switch to meet this policy?
1. Switch (config-if) # ip access-group 10
2. Switch (config-if) # switchport port-security maximum 1
3. Switch (config) # access-list 10 permit ip host 1
4. Switch (config-if) # switchport port-security violation shutdown
5. Switch (config) # mac-address-table secure