When using the loopback address, if TCP/IP is installed correctly, when should you receive a response?

Which address is the loopback address?

A

0.0.0.1

B

127.0.0.0

C

127.0.0.1

D

255.255.255.255

E

None of the above

When you ping the loopback address, a packet is sent where?

A

On the network

B

Down through the layers of the IP architecture and then up the layers again

C

Across the wire

D

through the loopback dongle

E

None of the above

Which of the following TCP/IP addresses constitute the loopback address?

A

1.1.1.1

B

255.255.255.255

C

127.0.0.0

D

127.0.0.1

Which of the following TCP/IP adress constitute the loopback address?

A

1.1.1.1

B

255.255.2555.255

C

127.0.0.0

D

127.0.0.1

What is the loopback address?

A

127.0.0.1

B

255.0.0.0

C

255.255.0.0

D

255.255.255.255.0

E

None of the above

If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

A

The Lowest IP address of any physical interface

B

The Highest IP address of any physical interface

C

The Lowest IP address of any logical interface

D

The Highest IP address of any logical interface

If 75% students of a class answered the first question in a test correctly, 55% answered the second question correctly and 20% answered neither of the questions correctly, what percent answered both the questions correctly?

A

50

B

34

C

44

D

14

If 75 percent of a class answered the first question on a certain test correctly, 55 percent answered the second question on the test correctly, and 20 percent answered neither of the questions correctly, what percent answered both correctly?

A

10%

B

20%

C

30%

D

50%

If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?

A

Discard it and send an error message back to the originating host

B

Flood the network with the frame

C

Add the source address and port to the MAC address table and forward the frame out the destination port

D

Add the destination to the MAC address table and then forward the frame

You need to gather the IP address of a remote switch that is located in Hawaii. What can you do to find the address?

A

Issue the show ip route command on the router connected to the switch

B

Issue the show cdp neighbor command on the router connected to the switch

C

Issue the show ip arp command on the router connected to the switch

D

Issue the show cdp neighbors detail command on the router connected to the switch

When using the loopback address, if TCP/IP is installed correctly, when should you receive a response?

Related Questions