Related Questions

Which of the following TCP/IP adress constitute the loopback address?
A 1.1.1.1
B 255.255.2555.255
C 127.0.0.0
D 127.0.0.1
Which address is the loopback address?
A 0.0.0.1
B 127.0.0.0
C 127.0.0.1
D 255.255.255.255
E None of the above
When you ping the loopback address, a packet is sent where?
A On the network
B Down through the layers of the IP architecture and then up the layers again
C Across the wire
D through the loopback dongle
E None of the above
When using the loopback address, if TCP/IP is installed correctly, when should you receive a response?
A Immediately
B Only if the address fails
C After the next host comes online
D Within two minutes
E None of the above
What is the loopback address?
A 127.0.0.1
B 255.0.0.0
C 255.255.0.0
D 255.255.255.255.0
E None of the above
If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?
A The Lowest IP address of any physical interface
B The Highest IP address of any physical interface
C The Lowest IP address of any logical interface
D The Highest IP address of any logical interface
If a switch receives a frame and the source MAC address is not in the MAC address table but the destination address is, what will the switch do with the frame?
A Discard it and send an error message back to the originating host
B Flood the network with the frame
C Add the source address and port to the MAC address table and forward the frame out the destination port
D Add the destination to the MAC address table and then forward the frame
which class of IP address has the most host addresses available by default ?
A A
B B & C
C C
D None
Which class of IP address has the most host addresses available by default?
A A
B B
C C
D A and B
Which of the following specifies the network address and host address of the computer?
A The IP address
B The TCP address
C The subnet mask
D The default gateway
E None of the above

Next steps