Related Questions

The capacity of a belt conveyor depends upon two factors. If one is the cross-section of the load, the other is the __________ of the belt.
A Speed
B Thickness
C Length
D None of these
__________ conveyor is the most suitable for long distance transportation of cold, non-abrasive granular/irregular shape/fine materials.
A Bucket
B Belt
C Screw
D Apron
For the transportation of ultrafine particles, the equipment used is a........conveyor.
A Belt
B Pneumatic
C Screw
D None of these
The maximum slope of a belt conveyor can be
A 15°
B 30°
C 45°
D 60°
Which is the most suitable conveyor for transportation of sticky material?
A Apron conveyor
B Belt conveyor
C Screw conveyor
D Pneumatic conveyor
Short distance transportation of grain, gravel, sand, ash, asphalt etc. is done by using a __________ conveyor.
A Flight
B Slat or drag
C Ribbon
D Screw
For same pulley diameters, center distance, belt speed and belt and pulley materials,
A Open belt drive transmits more power than crossed belt drive
B Crossed belt drive transmits more power than open belt drive
C Open and crossed belt drives transmit same power
D Power transmission does not depend upon open and crossed types of constructions
Load carrying capacity of belt conveyor is about
A 20 to 40 tonnes/hr
B 50 to 100 tonnes/hr
C 100 to 150 tonnes/hr
D 150 to 200 tonnes/hr
Width and speed of a conveyor belt depends upon the __________ of the material.
A Lump size
B Bulk density
C Both A & B
D Neither A nor B
The electronic conveyor-belt system, which Susan Park (A) adapted from a production-line method (B) pioneered by Thomas Langley, reduced the (C) required time being needed of assembling a SmartGadget device (D) from over ten hours to just 120 minutes.
A A
B B
C C
D D
E E

Next steps