Related Questions

The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is _________ cutting speed for drilling mild steel with high speed steel drills.
A Equal to
B Less than
C More than
D None of these
For machining a mild steel workpiece by a high speed steel tool, the average cutting speed is
A 5 m/min
B 10 m/ min
C 15 m/min
D 30 m/min
The allowable tensile stress in structural mild steel plates for steel tank is assumed as
A 95.0 MPa on net area
B 105.5 MPa on net area
C 105.5 MPa on gross area
D 150.0 MPa on gross area
The average cutting speed for turning mild steel with a high speed steel tool is
A 15 to 19 m/min
B 25 to 31 m/min
C 60 to 90 m/min
D 90 to 120 m/min
__________ is the most suitable lubricant for drawing mild steel wires?
A Kerosene
B Water
C Sodium stearate
D Lime water
The ultimate tensile stress for mild steel is __________ the ultimate compressive stress.
A Equal to
B Less than
C More than
D None of these
For machining a mild steel workpiece using carbide tool, the maximum material will be removed at a temperature of
A 500
B 1000
C 1750
D 2750
When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)
A 0.5 d
B 0.75 d
C d
D 1.25 d
Euler’s formula for a mild steel column is not valid if the slenderness ratio is
A 90
B 60
C 120
D 100
Mild steel belongs to the following category
A Low carbon steel
B Medium carbon steel
C High carbon steel
D Alloy steel

Next steps