Related Questions

The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is _________ cutting speed for drilling mild steel with high speed steel drills.
A Equal to
B Less than
C More than
D None of these
A garments factory employs 3 categories of workers K, M and N. The efficiency of the 3 categories of workers to do a specific task is in the ratio of 3 : 5 : 6 respectively and the factory employs 15 of category K, 12 of category M and 3 of category N. If the total wages paid to the entire group of 30 workers is Tk. 492 per hour, what will be the wages earned by a category N worker for an 8-hour day?
A Tk. 144
B Tk. 72
C Tk. 192
D Tk. 576
For machining a mild steel workpiece by a high speed steel tool, the average cutting speed is
A 5 m/min
B 10 m/ min
C 15 m/min
D 30 m/min
The allowable tensile stress in structural mild steel plates for steel tank is assumed as
A 95.0 MPa on net area
B 105.5 MPa on net area
C 105.5 MPa on gross area
D 150.0 MPa on gross area
The average cutting speed for turning mild steel with a high speed steel tool is
A 15 to 19 m/min
B 25 to 31 m/min
C 60 to 90 m/min
D 90 to 120 m/min
Mild steel is a/an __________ steel.
A Low carbon
B Medium carbon
C High carbon
D High alloy
Tensile strength of a mild steel specimen can be roughly predicted from following hardness test
A Brinell
B Rockwell
C Vickers
D None of the above
Which of the following is not shipped in mild steel containers?
A Acetone
B Ammonia
C Ethyl alcohol
D Formic acid
For machining a mild steel workpiece using carbide tool, the maximum material will be removed at a temperature of
A 500
B 1000
C 1750
D 2750
When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)
A 0.5 d
B 0.75 d
C d
D 1.25 d

Next steps