Related Questions

The loss of strength in compression with simultaneous gain in strength in tension due to overloading is known as
A Hysteresis
B Creep
C Visco elasticity
D Boeschinger effect
The yield point in fatigue loading compared to that in static loading is less. The ratio of ultimate tensile strength to endurance limit of a material subjected to fatigue loading is
A 0.5
B 1
C 1.5
D 2
When the belt is stationary, it is subjected to some tension known as initial tension. The value of this tension is equal to the
A tension in the tight side of the belt
B tension in the slack side of the belt
C sum of the tensions on the tight side and slack side of the belt
D average tension of the tight side and slack side of the belt
On selling a chair at 7% loss and a table at 17% gain, a man gains Tk 296. If he sells the chair at 7% gain and the table at 12% gain, then he gains Tk. 400. The actual price of the table is ---
A Tk. 2400
B Tk. 2200
C Tk. 1800
D Tk. 1600
Compression loss in I.C engines occurs due to
A Leaking piston rings
B Use of thick head gasket
C Clogged air inlet slots
D All of the above
The ratio of the cost of two articles is 7:3 . The first one was sold at a loss of 20% and the second one was sold at a gain of 40% What is the overall percentage of gain/loss?
A 2% loss
B 2 % gain
C 4% loss
D 4% gain
The advantage of multistage compression over single stage compression is
A Lower power consumption per unit of air delivered
B Higher volumetric efficiency
C Decreased discharge temperature
D All of the above
A plate with an elliptical hole in the centre, with semi-major axis (a) perpendicular to the direction of loading and semi-minor axis (b) along the direction of loading, is subjected to a pull P. The maximum stress induced at the edge of the hole is equal to (where $$\sigma $$ = Stress for a plate with no hole i.e. nominal stress)
A $$\sigma \left( {1 + \frac{{\text{b}}}{{2{\text{a}}}}} \right)$$
B $$\sigma \left( {1 + \frac{{2{\text{a}}}}{{\text{b}}}} \right)$$
C $$\sigma \left( {1 + \frac{{\text{b}}}{{3{\text{a}}}}} \right)$$
D $$\sigma \left( {1 + \frac{{3{\text{a}}}}{{\text{b}}}} \right)$$
The yield point in static loading is __________ as compared to fatigue loading.
A Higher
B Lower
C Same
D None of these
A shift register moves the _____ left or right. Serial loading means storing a word in a shift register by entering _____ bit per clock pulse. With parallel or broadside loading, it takes only one _____ pulse to load the input word.
A light, eight, clock
B right, eight, clock
C bits, one, register
D bits, one, clock
E None of the above

Next steps