Related Questions

Two outlets of a motor manufacturing company reported that revenue from outlet x in 2013 was down 11 percent from 2012. and revenue from outlet Y in 2013 were up 7 percent from 2012. If total revenue from outlet X & Y in 2013 was up 1 percent from 2012, what is the ratio of revenue from outlet X in 2012 revenue from outlet Y in 2012?
A 1 : 2
B 4: 5
C 1 : 1
D 3: 2
In a parallel flow heat exchanger, if the outlet temperature of hot and cold fluids are the same, then the log mean temperature difference (LMTD) is
A Minimum
B Maximum
C Zero
D Infinity
LMTD in case of counter flow heat exchanger as compared to parallel flow heat exchanger is
A Higher
B Lower
C Same
D Depends on the area of heat exchanger
In counter current flow heat exchanger, the logarithmic temperature difference between the fluids is ________ as compared to parallel flow heat exchanger.
A Same
B Less
C Greater
D None of these
In a heat exchanger, the rate of heat transfer from the hot fluid to the cold fluid
A Varies directly as the area and the LMTD
B Directly proportional to LMTD and inversely proportional to the area
C Varies as square of the area
D None of these
Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed in case of heat exchanger of the type
A Parallel flow with equal heat capacities
B Counter flow with equal heat capacities
C Counter flow with unequal heat capacities
D Parallel flow with unequal heat capacities
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is
A 0
B 1
C >1
In a shell and tube heat exchanger, putting a longitudinal baffle across the shell, forces the shell side fluid to pass __________ through the heat exchanger.
A Once
B Twice
C Thrice
D Four times
In a shell and tube heat exchanger, the outlet temperature of heating/cooling fluid is the __________ variable.
A Load
B Manipulated
C Controlled
D None of these

Next steps