Related Questions

In a liquid-liquid heat exchanger, for the same process temperature, the ratio of the LMTD in parallel flow to the LMTD in counter flow is always
A [

A.

B. > 1

B 1
C ∞
LMTD in case of counter flow heat exchanger as compared to parallel flow heat exchanger is
A Higher
B Lower
C Same
D Depends on the area of heat exchanger
In counter current flow heat exchanger, the logarithmic temperature difference between the fluids is ________ as compared to parallel flow heat exchanger.
A Same
B Less
C Greater
D None of these
LMTD correction factor which is to be applied for a cross-flow heat exchanger increases with increase in the number of shell passes. Its value for a single pass cross flow heat exchanger is
A 0
B 1
C >1
Two outlets of a motor manufacturing company reported that revenue from outlet x in 2013 was down 11 percent from 2012. and revenue from outlet Y in 2013 were up 7 percent from 2012. If total revenue from outlet X & Y in 2013 was up 1 percent from 2012, what is the ratio of revenue from outlet X in 2012 revenue from outlet Y in 2012?
A 1 : 2
B 4: 5
C 1 : 1
D 3: 2
In case of parallel flow heat exchanger, the lowest temperature theoretically attainable by the hot fluid is __________ the outlet temperature of the cold fluid.
A Equal to
B More than
C Less than
D Either more or less than (depending upon the fluid)
Parallel straight line pattern of temperature distribution for both hot and cold fluids is observed in case of heat exchanger of the type
A Parallel flow with equal heat capacities
B Counter flow with equal heat capacities
C Counter flow with unequal heat capacities
D Parallel flow with unequal heat capacities
log 3 + log 9 + log 27 + ……………i. ধারার পরবর্তী পদ log 81 ii. একটি সমান্তর ধারা iii. এর সাধারণ অন্তর log 6 নিচের কোনটি সঠিক?
A i ও ii
B i ও iii
C ii ও iii
D i, ii ও iii
log 3 + log 9+log 27+...... i. ধারাটির সাধারণ অনুপাত log 3 ii. ধারাটির প্রথম দশটি পদের সমষ্টি 55 log 3 iii. ধারাটি একটি গুণোত্তর ধারা নিচের কোনটি সঠিক?
A i
B ii
C i ও iii
D i, ii ও iii
Log mean temperature difference (LMTD) cannot be used, if
A Heat transfer co-efficient over the entire heat exchanger is not constant
B There exists an unsteady state
C The heat capacity is not constant and there is a phase change
D None of these

Next steps