Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In comparing the operation of the half-controlled 2-pulse circuit with that of the fully-controlled circuit, which of the following statements are evident? 1. Since half the thyristors are replaced by diodes, a half-controlled converter costs less than a fully-controlled converter. 2. Due to the freewheeling action with a half-controlled bridge-circuit power factor is improved in half-controlled converters. 3. The AC supply current is more distorted due to its zero periods with the half-controlled circuit, compared to a fully-controlled bridge circuit. Select the correct answer using the code given below :
Consider the following statements for an induction furnace: 1. High-frequency current is generally used for the furnace working. 2. There is less loss of alloying elements due to oxidation. 3. Pronounced stirring action of molten metal occurs inside the furnace. 4. Slag cover is essential for the efficient working of the furnace. Which of the above statements are correct?
Assertion (A): DC servomotors are more commonly used in armature controlled mode than field controlled mode. Reason (R): Armature controlled Dc motors have higher starting torque than fiels controlled motors.
Which of the following facts is/are correct about the blast furnace in Iron metallurgy? Limestone is added to the blast furnace to reduce the iron oxide in the ore to iron. Coke is added to the blast furnace to physically separate iron from other impurities. Carbon dioxide reduces to carbon monoxide.
Two long rods A and B of the same diameter have thermal conductivities k and 4k and have one of their end inserted into a furnace at 400 K. At 9.5 m away section from the furnace, the temperature of rod B is120 degree Celsius. So find out at what end from the furnace end, the same temperature would be reached in the rod A?
A cylindrical stainless steel (k = 25 W/m K) ingot, 10 cm in diameter and 25 cm long, passes through a heat treatment furnace which is 5 meter in length. The initial ingot temperature is 90 degree Celsius, the furnace gas is at 1260 degree Celsius and the combined radiant and convective surface coefficient is 100 W/m2 K. Determine the maximum speed with which the ingot moves through the furnace if it must attain 830 degree Celsius temperature. Take thermal diffusivity as 0.45 * 10 -5 m2/s
Combustion of furnace oil in a furnace (soaking pit) with preheated combustion air at 400°C results in saving of about __________ percent furnace oil as compared to its combustion with atmospheric air, if the flue gas outlet temperature from the soaking pit is 1200°C.
The highest pressure gas of a mixture has partial pressure p, the partial pressure of other gases decreases by factor of 2n-1, the partial pressure of second gases decreases by a factor of 2, partial pressure of third gas increases by 4, and so on, if the total pressure of gas mixture is 31p/16, how many gases are present in the mixture?
An Op-Amp can be connected to provide 1. Voltage controlled current source 2. Current controlled voltage source 3. Current controlled current source Which of the above statements are correct?
The flow rate of steam is controlled by regulating the _________