Related Questions

Rate of heat release in a furnace, which is the measure of heat intensity is defined as
A kcal/hr/m3 combustion space
B kcal/m3 combustion space
C kcal/hr
D None of these
Extended heat transfer surface like fins are used to increase the heat transfer rate. Fin efficiency is defined as the ratio of heat transferred across the fin surface to the theoretical heat transfer across an equal area held at the
A Surrounding temperature
B Average temperature of the fin
C Temperature of the fin end
D Constant temperature equal to that of the base
Travelling at a constant speed of 32 miles per hours, a certain motorboat consumers 24gallons of fuel per hour. What is the fuel consumption of his boat this speed measured in miles per gallons of fuel?
A 2/3
B 3/4
C 4/5
D 4/3
A certain truck uses 18 gallons of diesel fuel in traveling 270 miles. In order for the truck to travel the same distance using 10 gallons of diesel fuel, by how many miles per gallon must the truck's fuel mileage be increased.
A 12
B 15
C 27
D 9
Two tanks are filled to capacity with automobile fuel. The first tank holds 600 gallons more than the second tank. If 100 gallons were to be pumped from each tank, the first tank would then contain 3 times as much fuel as the second tank. What is the total number of gallons of fuel in the two full tanks?
A 1,400
B 1,200
C 1,000
D 900
How are the efficiencies of any heat engine (miu) and reversible heat engine (miuR) compared, when both are operating between same heat source and same heat sink?
A miu = miuR
B miu>miuR
C miu
D none of these
The scales form in heat exchanges after a period of operation and provide additional resistance to heat transfer with some heat transfer coefficient . The reciprocal of this scale heat transfer coefficient is called .
A scaling factor
B forming factor
C resisting factor
D fouling factor
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
Gasification of the solid fuel converts its organic part into combustible by interaction with air/oxygen and steam so as to obtain a secondary gaseous fuel of high calorific value having no ash. Gasification reactions are normally carried out at about __________ °C.
A 400-500
B 900-1000
C 1400-1500
D 1700-1800
Heat release during phase change is observed in case of a/an
A Boiler
B Condenser
C Evaporator
D All of the above

Next steps