Related Questions

একটি পানিপূর্ণ কুয়ার গভীরতা 20m ও ব্যাস 2 m. কুয়াটিকে পানি শূণ্য করার জন্য 5 HP এর একটি পাম্প লাগানো হল। অর্ধেক পানি তোলার পর পাম্পটি নষ্ট হয়ে গেল। বাকি পানি তোলার জন্য একই ক্ষমতা সম্পন্ন আর একটি পাম্প লাগানো হল। প্রথম পাম্প দ্বারা সম্পাদিত কাজের পরিমান নির্ণয় কর।(The depth and diameter of a water filled well are 20 m and 2 m respectively. An engine of 5 HP is attached to pump out the water. The pump was ruined after emptying half of the water. Then another pump of same capacity was attached to pump out rest of the water. Determine the work done by first pump.) 
A 2.54 × 104 J
B 1.44 × 104 J
C 2.34×104 J
D 1.54 × 104 J
E 1.54 ×104 J
Working alone, pump A can empty a pool in 3 hours. Working alone, pump B can empty the same pool in 2 hours. Working together, how many minutes will it take pump A and pump B to empty the pool?
A 72
B 75
C 84
D 96
A centrifugal pump designed to pump water is employed to pump a more viscous oil. In the later case, the pump
A Develops a lower head
B Capacity is reduced
C Requires more power
D All of the above
Which is the correct relationship for a centrifugal pump? (where, D = Impeller diameter, inches H = Head developed, ft of liquid pumped N = Speed of pump, rpm)
A D = 1840 H0.5/N
B D = 1840 N/H0.5
C H = 1840 D0.5/N
D D = 1840 H/N
Medium viscosity lubricating oil can be most ideally pumped by a __________ pump.
A Vane
B Piston
C Centrifugal
D Plunger
Which of the following is the most suitable for handling fibrous and dense slurries?
A Propeller agitator
B Cone type agitator
C Turbine agitator
D Radial propeller agitator
A boat has a crack in its bull which is leaking water into the boat and could pump which can pump the water out in 8 hours . If the boat is 168 km away from the shore and the pump is running what is the minimum speed the boat should run at so that it can reach the shore before sinking?
A 5km./hour
B 6 km/hour
C 7 km/hour
D 8km/hour
Crude oil is pumped by a __________ pump.
A Gear
B Centrifugal
C Screw
D Reciprocating
Flow rate of high velocity flue gas discharged through a stack to the atmosphere can be most conveniently measured by a
A Pitot tube
B Manometer
C Rotameter
D None of these
Open channel liquid flow is most conveniently measured by a
A Hot wire anemometer
B Notch
C Rotameter
D Segmental orifice

Next steps