Bissoy.com
Doctors Medicines MCQs Q&A

Uniform fluid flow occurs, when the derivative of the flow variables satisfy the following condition.

Uniform fluid flow occurs, when the derivative of the flow variables satisfy the following condition. Correct Answer $$\frac{\partial }{{\partial {\text{s}}}} = 0$$

Related Questions

Bernoulli's equation for fluid flow is derived following certain assumptions. Out of the assumptions listed below, which set of assumptions is used in derivation of Bernoulli's equation?
1. Fluid flow is frictionless & irrotational
2. Fluid flow is steady
3. Fluid flow is uniform & turbulent
4. Fluid is compressible
5. Fluid is incompressible
Steady fluid flow occurs, when the derivative of flow variables satisfy the following condition.
Which of the following statements is/are CORRECT regarding the flow of fluid? a) All fluid layers are parallel to each other in case of turbulent flow. b) The Reynold’s number is less than 2000 for turbulent flow and greater than 4000 for laminar flow. c) Two fluid layers don’t cross each other in case of laminar flow
For turbulent flow (NRe > 2100) of low viscosity fluid (μ > 20cp) in steel pipes, the optimum inside pipe diameter is given by (where, Q = fluid flow rate, ft3/sec.ρ = fluid density, lb/ft3.μ = fluid viscosity, centipoise Di = optimum inside pipe diameter, inches)
Flow at constant rate through a tapering pipe is
i) steady flow
ii) uniform flow
iii) unsteady flow
iv) non-uniform flow
The correct answer is
The important parameters describing the performance of a hydraulic machine are: P the power input, H the head produced across the machine and the efficiency, η. For a given geometrical design of the machine, the performance is characterized by the variables: H – the head increase across the machine ρ – the fluid density, ω – the angular velocity of the rotor, D – the diameter of the rotor, μ  – the fluid viscosity and Q – the flow rate; and both P and η are expressed through these variables. How many non-dimensional parameters are involved herein? Gravitational acceleration g has also to be considered necessarily?
A person X from a place A and another person Y from a place B set out at the same time to walk towards each other. The places are separated by a distance of 15 km. X walks with a uniform speed of 1.5 km / hr and Y walks with a uniform speed of 1 km / hr in the first hour, with a uniform speed of 1.25 km / hr in the second hour and with a uniform speed of 1.5 km / hr in the third hour and so on. Which of the following is / are correct? 1. They take 5 hours to meet. 2. They meet midway between A and B. Select the correct answer using the code given below:
Which of the following statements are true about quicksand? i. It is only a condition but not a type of sand. ii. It is a condition and a type of sand too. iii. Quicksand condition reaches when critical hydraulic gradient is approximately equal to unity. iv. Quicksand condition occurs more commonly in coarse grained sand or gravels than fine sand.
Surge wave in a rectangular channel is an example of
i) steady flow
ii) unsteady flow
iii) uniform flow
iv) non-uniform flow
The correct answer is
The question below consists of a set of labelled sentences. Out of the four options given, select the most logical order of the sentences to form a coherent paragraph. P: The primary software tool used to do this is the spreadsheet. Spreadsheet language allows the financial modeller to reconstruct almost any cash flow or revenue stream. Q: A financial model tries to capture all the variables in a particular event. It then quantifies the variables and creates formulas around these variables. R: The model is usually characterised by performing calculations and makes recommendations based on that information. S: Financial modelling is the process by which a firm constructs a financial representation of some, or all, aspects of the firm or given security.