Related Questions

The angle of contact between a glass capillary tube of length 10 cm and a liquid is 90 degree . If the capillary tube is dipped vertically in the liquid, then the liquid:
A Will rise in the tube
B Will get depressed in the tube
C Will rise -up to 10 cm in the tube and will over flow
D Will neither rise nor fall in the tube.
The angle of contact between a glass capillary tube of length 10 cm and a liquid is 90 Degree. If the capillary tube is dipped vertically in the liquid, then the liquid:
A Will rise in the tube
B Will get depressed in the tube
C Will rise-up to 10 cm in the tube and will over flow
D Will neither rise not fall in the tube
A liquid would wet the solid, if adhesion forces as compared to cohesion forces are
A Less
B More
C Equal
D Less at low temperature and more at high temperature
When a tube of smaller diameter is dipped in water, the water rises in the tube with an upward __________ surface.
A Concave
B Convex
C Plane
D None of these
The product P of two prime numbers is between 9 and 55. If one of the prime numbers is greater than 2 but less than 6 and the other is greater than 13 but less than 25, then P =
A 15
B 33
C 34
D 51
L is older than M and taller than N. O is younger than P, older than N and shorter than Q. R is older than S, younger than N, shorter than S and taller than Q. S is older than L, M, O, P, Q, R and S is necessarily false?
A O is the shortest of the group.
B N is the second tallest of the group.
C L is the tallest of the group.
D Q is the third oldest of the group.
For the same heat load and mass flow rate in the tube side of a shell and tube heat exchanger, one may use multipass on the tube side, because it
A Decreases the pressure drop
B Decreases the outlet temperature of cooling medium
C Increases the overall heat transfer coefficient
D None of these
Air is to be heated by condensing steam. Two heat exchangers are available (i) a shell and tube heat exchanger and (ii) a finned tube heat exchanger. Tube side heat transfer area are equal in both the cases. The recommended arrangement is
A Finned tube heat exchanger with air inside and steam outside
B Finned tube heat exchanger with air outside and steam inside
C Shell and tube heat exchanger with air inside tubes and steam on shell side
D Shell and tube heat exchanger with air on shell side and steam inside tubes
In most of the shell and tube heat exchangers, the tube pitch is generally __________ the tube diameter.
A Less than
B 1.25-1.50 times
C 2.5 times
D One-fourth of
For the same diameter and thickness of tube, a water tube boiler has ________ heating surface as compared to fire tube boiler.
A More
B Less
C Equal
D None of these

Next steps