Related Questions

In a compound steam engine, the first stage of expansion is carried out in a high pressure cylinder whereas the last expansion is completed in low pressure cylinder. The diameter of high pressure cylinder is _________ the low pressure cylinder.
A Equal to
B Less than
C More than
D None of these
The variable required to be known in correlations used for estimating the horse power of a centrifugal gas compressor and hence its cost are P. Inlet pressure Q. Compressor rpm R. Delivery pressure S. Volumetric flow rate at inlet.
A P, Q and R
B P and R
C R and S
D P, R and S
A compressor that takes suction at a pressure below atmospheric and discharge against atmospheric pressure is called a __________ pump.
A Sump
B Volute
C Vacuum
D Submerged
The discharge over the trapezoidal notch is equal to the discharge over the rectangular notch __________ the discharge over the triangular notch.
A Plus
B Minus
C Divide
D None of these
Horsepower increase of a centrifugal gas compressor without altering the volumetric flow rate will __________ the gas discharge pressure.
A Increase
B Decrease
C Not change
D Exponentially decrease
In an axial flow compressor, the ratio of pressure in the rotor blades to the pressure rise in the compressor in one stage is known as
A Work factor
B Slip factor
C Degree of reaction
D Pressure coefficient
For very high discharge at low pressure such as for flood control and irrigation applications, following type of pump is preferred
A Centrifugal
B Axial flow
C Reciprocating
D Mixed flow
A company produces five types of shirts -- A,B,C,D and E-using cloth of three qualities -- high, medium and low , using dyes of three qualities-- high, medium and low. One shirt requires 1.5 m of cloth .The following table gives respectively : The number of shirts (of each category) produced, in thousands. The percentage distribution of cloth quality in each type of shirt, and The percentage distribution of dye quality in each type of shirt. What is the ratio of low quality dye used for C-type shirts to that used for D-type shirts ?
A 2:3
B 1:2
C 2:1
D 3:2
A pressure gauge on the discharge side of a refrigerant compressor reads too high. The reasons will be
A Lack of cooling water
B Water temperature being high
C Dirty condenser surface
D All of these
A company produces five types of shirts -- A,B,C,D and E-using cloth of three qualities -- high, medium and low , using dyes of three qualities-- high, medium and low. One shirt requires 1.5 m of cloth .The following table gives respectively : The number of shirts (of each category) produced, in thousands. The percentage distribution of cloth quality in each type of shirt, and The percentage distribution of dye quality in each type of shirt. How many meters of low-quality cloth is consumed?
A 40,00 m
B 60,000 m
C 46,500 m
D 22,500 m

Next steps