Related Questions

In an ideal refrigeration cycle, the change in internal energy of the fluid is
A +ve
B -ve
C 0
D Either of the above three ; depends on the nature of refrigerant
STP-তে একটি আদর্শ গ্যাসকে প্রথমে তার প্রাথমিক আয়তনের এক-তৃতীয়াংশে সংকুচিত করা হয়, এবং তারপর প্রসারিত হতে দেওয়া হয় যতক্ষণ না তার চাপ প্রাথমিক চাপের অর্ধেক হয়। উভয় প্রক্রিয়ায় গ্যাসের তাপমাত্রা স্থির থাকে। যদি গ্যাসের প্রাথমিক অভ্যন্তরীণ শক্তি । হয়ে থাকে তাহলে এর চূড়ান্ত অভ্যন্তরীণ শক্তি কত? (An ideal gas at STP is first compressed to one-third of its initial volume and then allowed to expand until its pressure is half the initial pressure. The temperature of the gas remains constant during both the processes. If the initial internal energy of the gas is U, what is its final internal energy?)
A U/3
B U/2
C U
D 2U/3
A refrigeration cycle is a reversed heat engine. Which of the following has the maximum value of the co-efficient of performance (COP) for a given refrigeration effect?
A Vapor compression cycle using expansion valve
B Air refrigeration cycle
C Vapor compression cycle using expansion engine
D Carnot refrigeration cycle
Humidity chart is useful for the solution of problems concerning condensation, vaporisation and air conditioning. At a given dry bulb temperature, value of humidity obtained from the humidity chart directly, is in terms of __________ humidity.
A Molal
B Relative
C Percentage
D None of these
The change in evaporator temperature in a refrigeration cycle, as compared to change in condenser temperature, influences the value of C.O.P.
A More
B Less
C Equally
D Unpredictable
A refrigeration cycle is the same as a __________ cycle,
A Turbine
B Heat engine
C Reversed heat engine
D None of these
Ideal refrigeration cycle is
A Same as Carnot cycle
B Same as reverse Carnot cycle
C Dependent on the refrigerant's properties
D The least efficient of all refrigeration processes
Internal energy change of a system over one complete cycle in a cyclic process is
A Zero
B +ve
C -ve
D Dependent on the path
The internal energy of an ideal gas does not change in a reversible __________ process.
A Isothermal
B Adiabatic
C Isobaric
D Isometric
When the load on the engine increases, it becomes necessary to increase the supply of working fluid and when the load decreases, less working fluid is required. The supply of the working fluid to the engine is controlled by a
A D-slide valve
B governor
C Meyer’s expansion valve
D flywheel

Next steps