Related Questions

When the temperature of air leaving the inter-cooler, in a two stage compression with inter-cooler, is ________ the original atmospheric air temperature, then the intercooling is known as perfect or complete intercooling.
A Equal to
B Less than
C More than
D None of these
A contractor employed 30 men to do a piece of work in 38 days. After 25 days , he employed 5 men more and the work was finished one day earlier. How many days he would have been behind, if he had not employed additional men?
A 1
B 114
C 134
D 112
In a centrifugal compressor, the flow of air is ________ to the axis of compressor.
A Parallel
B Perpendicular
C Inclined
D None of these
If the flow of air through the compressor is parallel to its axis, then the compressor is
A Reciprocating compressor
B Centrifugal compressor
C Axial flow compressor
D Turbo compressor
According to an engineer (P) might hit the market next year (Q) a newly developed air-cooler system (R) that employed in conventional room coolers (S) which is based on a principle radically from
A PQRS
B QSRP
C RSQP
D SQRP
Noise produced by cooling fans (employed in air cooled heat exchangers or cooling tower) is mainly caused due to the turbulence created by blade passage through air. It can be reduced by use of a slower fan
A With greater number of blades
B Of increased diameter
C Both A & B
D Neither A nor B
Axial flow compressor has the following advantage over centrifugal compressor
A Larger air handling ability per unit frontal area
B Higher pressure ratio per stage
C Aerofoil blades are used
D Higher average velocities
Which is false statement about advantages of multistage compressor in comparison to single stage compressor?
A Less power requirement
B Better mechanical balance
C Less loss of air due to leakage past the cylinder
D Lower volumetric efficiency
In an axial flow compressor, the ratio of pressure in the rotor blades to the pressure rise in the compressor in one stage is known as
A Work factor
B Slip factor
C Degree of reaction
D Pressure coefficient
For very low pressure and high discharge rate, the compressor used is a/an __________ compressor.
A Axial
B Reciprocating
C Rotary
D None of these

Next steps