Related Questions

The method of moving each brick through a small horizontal distance before it is finally laid in any brick wall and pressing it by means of brick hammer, is known as
A Troweling
B Laying
C Grouting
D Placing
Nogging of a common wooden partition is
A Upper horizontal wooden member
B Lower horizontal wooden member
C Intermediate horizontal wooden member
D Vertical wooden member
The solid brick shown is made of small square shaped bricks of side 1. when the large brick is disassembled into its component small bricks. the total surface area of all the small bricks is how much greater than the surface area of the large brick?
A 32
B 40
C 60
D 72
The expected out turn of half brick partition wall per mason per day is
A 1.5 m2
B 2.0 m2
C 4.0 m2
D 5.0 m2
The thickness of a reinforced brick partition wall, is generally kept
A 5 cm
B 10 cm
C 15 cm
D 20 cm
A ladder is resting against a vertical wall and its bottom is 2.5 m away from the wall. If it slips 0.8 m down the wall, then its bottom will move away from the wall by 1.4 m. What is the length of the ladder?
A 6.2 m
B 6.5 m
C 6.8 m
D \7.5 m
For you to create a swap partition by using fdisk, what must the partition's system ID type be?
A 83
B 82
C 5
D 4
E None of the above
The piece of a brick cut along the centre of width in such a way that its length is equal to that of full brick, is called
A Half brick
B Queen closer
C King closer
D Bevelled closer
The piece of a brick cut with its one corner equivalent to half the length and half the width of a full brick, is known as
A Queen closer
B Bevelled closer
C King closer
D Half king closer
The frog of the brick in a brick masonry is generally kept on
A Bottom face
B Top face
C Shorter side
D Longer side

Next steps