Bissoy.com
Doctors Medicines MCQs Q&A

Related Questions

In counterfort type retaining walls
i) the vertical slab is designed as a continuous slab
ii) the heel slab is designed as a continuous slab
iii) the vertical slab is designed as a cantilever
iv) the heel slab is designed as a cantilever
The correct answer is
In counterfort type retaining wallsi) the vertical slab is designed as a continuous slabii) the heel slab is designed as a continuous slabiii) the vertical slab is designed as a cantileveriv) the heel slab is designed as a cantileverThe correct answer is
From the given table, what is the percentage of students scoring 40 or more, but less than 70. Scores Less than 20 Less than 30 Less than 40 Less than 50 Less than 60 Less than 70 Less than 80 No. of Students 12 19 22 31 38 46 50
Which of the following are the general design requirements of retaining wall? 1. The factor of safety against sliding should be at least 1.5 2. The factor of safety against over-turning should be at least 2.0 3. The bearing pressure at toe should be less than the bearing capacity of the soil 4. The length of retaining wall to be cast in one go should not exceed 10 m otherwise cracks may develop 
Examine the following statements :
i) Factor of safety for steel should be based on its yield stress,
ii) Factor of safety for steel should be based on its ultimate stress,
iii) Factor of safety for concrete should be based on its yield stress,
iv) Factor of safety for concrete should be based on its ultimate stress.
The correct statements are
From the following table, how many patients were in the age group 40 – 60? Age (years) Less than 10 Less than 20 Less than 30 Less than 40 Less than 50 Less than 60 Less than 70 No. of patients 11 15 22 29 35 45 50
In the question below, are given a statement followed by three courses of actions numbered I, II and III. On the basis of the information given, you have to assume everything in the statement to be true, and then decide which of the following suggested courses of actions logically follow(s) for pursuing. Statement: Starting October, all new cars will have pedestrian safety features, including new design of the bonnet, to reduce impact on pedestrians during accidents. Advanced safety features are needed in all vehicles in India as vehicle safety cannot be confined to luxury vehicles only. Around 1.5 lakh people are killed in road accidents every year in the country, nearly 60% of them are pedestrians.  Courses of action: I. The government has set a target to reduce the number of road deaths by half in the next two years. The ministry of road transport and highways has been issuing new safety standards for the automobiles along with eliminating the black spots on national highways.  II. By next month, all new cars will have pedestrian safety feature, including new design of the bonnet, to reduce impact on pedestrians during accidents.  III. Ministry of road transport and Highways is planning to implement all safety features in vehicles with active support of vehicle manufacturers. Electronic stability control (ESC) and autonomous emergency braking (AEB) will be incorporated in new vehicles by 2022.
Study the table and answer the question. The table shows the daily income of 50 persons. Income (Rs.) No. of persons less than 200 12 less than 250 26 less than 300 34 less than 350 40 less than 400 50 How many persons earn Rs.250 or more but less than Rs.350 daily?
The table shows the daily income of 50 persons. Study the table and answer the question. Income (Rs.) No. of persons less than 200 12 less than 250 26 less than 300 34 less than 350 40 less than 400 50 What is the ratio of the number of persons earning less than Rs. 200 to the number of persons earning Rs. 300 or more?
During a medical check-up, the heights of 40 students in a class were recorded as shown in the following table. Height (in cm) Less than 175 Less than 170 Less than 165 Less than 160 Less than 155 Less than 150 Number of students 40 35 25 16 8 4   How many students have a height of 165 cm or more?