Related Questions

In a center lathe, the cutting tool is fed in _________ with reference to the lathe axis.
A Cross direction only
B Longitudinal direction only
C Both cross and longitudinal direction
D Any direction
The taper on the lathe spindle is
A 1 in 10
B 1 in 15
C 1 in 20
D 1 in 30
A and B go cycling in the same direction with speeds of 6 km /hr and 12 km/hr. A car from behind passes them in 9 and 10 seconds respectively . What is the speeds of the car?
A 22 km/hr
B 33 km/hr
C 66 km/hr
D 44 km/hr
An ice cream parlour makes an ice cream using one of six different flavors of ice cream, one of three different flavor of syrup, and one of four different toppings. what is the total number of different ice creams that this ice cream paolour can make?
A 72
B 36
C 30
D 26
The lead screw of a lathe with nut forms a
A sliding pair
B rolling pair
C screw pair
D turning pair
Lathe bed is made of
A Mild steel
B Alloy steel
C Pig iron
D Chilled cast iron
Which of the following statement is incorrect with reference of lathe cutting tools?
A The flank of the tool is the surface or surfaces below and adjacent to the cutting edges
B The nose is the corner, arc or chamfer joining the side cutting and the end cutting edges
C The heel is that part of the tool which is shaped to produce the cutting edges and face
D The base is that surface of the shank which bears against the support and takes tangent pressure of the cut
The angle between the lathe centres is
A 30°
B 45°
C 60°
D 90°
The size of a lathe is specified by the
A Length between centers
B Swing diameter over the bed
C Swing diameter over the carriage
D All of these
The lead screw of a lathe has _________ threads.
A Single start
B Double start
C Multi-start
D Any one of these

Next steps